Recent content by mightyberry

Right, I didn't know that. Thanks!

Yeah, noticed that too on my AC88u, but only on channels higher than 48. On lower both 5Ghz and 2,4Ghz come online at the same time.

FTP looks FTP looks very good, but samba is a bit low. I was getting about 25MB/S worst (read) and 23MB/S write) by wire.

I really can't tell as some weeks ago I bought an AC88u + a NAS so I don't have the old router. It was simply too much of a hassle to reboot the router each time by the power button and hope the nothing breaks after a firmware update. Now everything is perfectly stable.

Right so there appears to be a workaround for the issue. Basically if you reboot the router from the GUI or reboot command from shell it will always get stuck on USB 2.0 speeds (at least my unit). If you reboot the router via the power button on the back it works fine, but if you want to...

Yup, the USB 3.0 interference reduce was disabled, while TX power was set to maximum. After decreasing it to 85% on both bands I got a boost in transfer rates of about 4MB/S (how come?). But the restart issue still persists...

The drive is connected only through a USB 3.0 single plug and its formatted to EXT4. So the situation at this point looks like this: On Friday I did the following - the drive was always plugged in: -flashed the latest official Asus firmware 3.0.0.4.380.3264 - once it came back - restored...

It's a 2,5 inch USB powered drive.

So i followed the guide to the letter. After completing the last step I disabled the USB 3.0 noise reduction, plugged in the drive and re-enabled network shares. At this pointy the transfer rates where about 44MB/S so good. I did a reboot to confirm that it will stay this way and it did. In the...

Hello, So I own a Asus AC68u router with Merlin 380.59 firmware and a Western Digital My Passport Ultra attached to it via USB 3.0. The USB 3.0 noise reduction is set off. Normally I get transfer rates while copying files from the drive to my PC of around 40-50 megabytes per second (large...