Recent content by monorailmedic

That may well be the case - so then we still end up with the core issue of "why doesn't this work?" I'm remoted into a box on the network in question and I can't reach anything on the tailnet. Devices connected to Tailscale via any other connection can see each other, admin shows the router in...

Found this as I have the same setup but Tailscale is not working right. I run the WAN Failover script via AMTM (which I also used to install Tailmon) on an AX58U running Merlin (a version from prob a year ago? I should update but sometimes that gets fickle). My failover is TMOHI, my main is...

Interesting. What's peculiar is that I did try to swap this to the kernel last night (which locked up my router for a bit...that was fun), and it still didn't work. Confirmed it was running in the kernel, but no 100* on the routing table and no accessing non-local clients in my tailnet.

I used the standard userspace mode from the beginning. Interestingly, if I look at the route table I don't see any 100.* IPs, which would seem odd to me. default via 192.168.88.1 dev eth4 127.0.0.0/8 dev lo scope link 192.168.12.0/24 dev eth3 proto kernel scope link src 192.168.12.221...

Same here. This is really odd.

Not sure how/why this would work (since IP's don't use name resolution) but set it to my gateway IP to check and still no dice.

My operators are below. As you see, the only difference is my subnet range (appropriate for this network) and --accept-routes (which I believe should be set, but to be clear, I've tested without it). --advertise-exit-node --advertise-routes=192.168.29.0/24 --accept-routes I keep wondering...

I installed this last night on my AX58U and added to my existing tailnet. In admin I can see the router, I can even use it as an exit node (though I have a NAS running Tailscale for that purpose). For whatever reason, however, I can't access machines on the tailnet from behind that router. In...

Today my primary WAN went down and things didn't switch over. I was on 2.0.2 at the time. I couldn't see why ti didn't work, as I had 100% packet loss on the primary, and all looked good with the secondary, but it wasn't switching. I manually switched and updates to 2.0.5 then restarted the...

I did a a WPS reset and setup everything again (remembered to copy/screenshot my IP reservations and such!) and so far performance is looking better. The UI actually loads way faster, too - which is certainly a red flag that there were some issues previously. I do still see some deauths, but...

I suppose it's possible that at some point I did that...but I have NO idea when, as I'd never heard of it, and the only guest network functionality I created was through the UI as I didn't have any special needs. I only learned it was installed when I ran amtm for the first time (didn't know it...

Disabled SmartSelect just before this reply. Looks like deauths are continuing, but I'll give things a few to stabilize given that this change alone, I suspect, would cause quite a bit of disconnecting and reconnecting. It seems to have been installed with one of the images along the way - but...

Still seeing dauths after disabling DFS :-/

I just disabled it now.

Because of the other factors I can't pinpoint it. I was thinking of downgrading as a shot in the dark. Need to look up the process. I have backups. No. I stay up to date on updates, and I think the Merlin docs mention resetting if jumping across multiple updates. Would a factory update be...