Recent content by moomoo71

Final update - The original router has two malfunctioning LAN ports. Everything works fine if I only use ports 1 and 2. I need more than that, so I'm just going to sell the original. Thanks for everyone's input.

48 hours later, the router swap worked. Still need to do a clean install on the previous one to see if was hw or sw.

Update: I was also having trouble with an Ethernet link to one of the mesh nodes, so I replaced the router and did a fresh config. So far, so good and the wired connection started working again. I'll test the old router on my home office LAN once I'm confident the replacement fixed the issue.

It's in router mode with 2 mesh nodes. All same model. Just happened again. I can access the router from my PC. Internet shows up. However, I cannot ping to another device, nor can I access the internet from SSH or the speed test in the router.

I just used poor wording. Fixed verbiage. All wired and wireless devices are connected but cannot access the Internet. Wan shows up, Lan ports show up and WiFi is up when this happens. Nothing can seem to get to the Internet though. Rebooting fixes it for a while. Qos and Trend Micro security...

I'm on the latest firmware, 388.8. I was hoping the update would fix it since it seemed like it started happening after the previous update. I'll try a clean install though. If worse comes to worst, I'll try the stock FW. Thanks.

I've found similar issues but not a solution that has worked.

Hello, For the past few weeks, just as the title states, everything appears to be working but no traffic passes and all devices remain connected but cannot access the Internet. I have quite a bit of experience with networking in general, but not Merlin. I am attaching the syslog. If you look...