Recent content by MordredKLB

Well, I just checked and Enable Custom Scripts was already set. I never rebooted my router though. That might have sorted the problem on it's own.

I had to manually run sh firewall-startup and now everything is working like a charm. Thanks for your help.

Output of that command: Saving Changes ipset v6.29: The set with the given name does not exist ipset v6.29: The set with the given name does not exist ipset v6.29: The set with the given name does not exist Restarting Firewall Service Done.

I'm having some issues getting this to run. I installed it in debug mode on /jffs, and then immediately sh firewall debug info: Router Model: RT-AC3100-B5C0 Skynet Version: v5.0.1 (29/06/2017) iptables v1.4.14 - (eth0) ipset v6.29, protocol version: 6 FW Version: 380.65_4 (Mar 29 2017) Install...

Only one other AC channel the router can see (on band 40). I'm on 149 and having no issues with interference as far as I can tell. I tried a few others on router #2 and didn't see any obvious improvement. Router #3 definitely is doing better. I think it's not as good as thought #1 was doing, but...

Things I tried this afternoon: I disabled Airtime Fairness and MU-MIMO and neither made a difference. I angled two of the antennas slightly towards the first floor, didn't make a difference. I restored the official ASUS firmware and did a default reset. No change. I did not because I never...

Fair point. I'll try that first. Assuming the speeds don't increase, do you have any thoughts? I should also mention that the only changes I made to settings in the firmware was enabling ping, ssh, and MU-MIMO. Is it worth disabling MU-MIMO and seeing if anything changes?

I'd hate to lose the AsusMerlin stuff, but I might do that. Just in case you missed it, these were two different routers. One that appeared to be working better than I could have expected for all of 4 hours, and a second one that seems to be having range issues.

Think I posted this in the wrong forum. I am running the latest official Merlin though so if there's settings I should try, I'm down.

I've got a 2800sf 2-story house with my entry point setup (100Mbit cable) on the 2nd floor close to a corner of the house. On Tuesday after reading reviews and this forum I bought an AC-3100. Set it up, updated the stock firmware, and was absolutely blown away. I ran all over the house with my...