Recent content by niwmik

Thanks, I'll give this a try. In regards to why I use 8T instead of 5T on my rt-ac68u, I believe it's because I have NAT Acceleration turned on based off of the info found at: https://elatov.github.io/2017/04/revert-to-asus-wrt-from-dd-wrt-on-asus-rt-ac68u-router/ When I run "robocfg show", I...

I'm trying to get this to work with a RT-AC68U (ASUSWRT-Merlin 384.6) and a UniFi AP-AC-Pro. My dnsmasq.conf.add and nat-start files are exactly the same as the ones in post #3. I have the UniFi AP-AC-Pro plugged into port 4 of the RT-AC68U. Looking at the router's log file, I see that the...

The 1st wireless access point is a UniFi AP-AC-Pro with firmware 3.9.27.8537. I'm using UniFi Controller 5.6.39. The 2nd wireless access point is a wireless router re-purposed as a wireless access point. It is a DIR-850L with firmware 1.12WW.

I have the following network setup and everything besides the dhcp issue works as it should. I have 2 vlan's separated from each other with Internet access. All hardwired computers do not have any issues with DHCP. The issue I'm having is that some wifi clients going through either wireless...

if I followed this strategy and I'm on 380.62_1 for rt-ac68p, would I update with the following firmwares in sequence and I wouldn't have to reconfigure? 380.63_2 380.64_2 380.65_4

If I want the device with mac address aa:bb:cc:dd:ee:ff to access the internal network, would I add the line "ebtables -t broute -I BROUTING -p IPv4 -i vlan10 --src aa:bb:cc:dd:ee:ff --ip-dst 192.168.1.0/24 --ip-proto tcp -j ACCEPT" to the script? Tested on the router and it didn't work...

Thanks for this script. I'll be using this in conjunction with a wireless AP. Is there anyway to allow certain mac addresses to have access to the internal network?

thanks RMerlin, i'll just manually add a port foward instead of using upnp

I'm running Asuswrt-Merlin 3.0.0.4.372.31. I have myPlex set to publish itself using UPnP and everything works. I see the UPNP-forwarded port listed on the System Log page, under Port Forwarding. However, the port forwarding will disappear after awhile. I have also notice that we have had...