Recent content by nos

Router is a freebie I want to restore; found some parts on amazon that may be workable.

Have two broken antenna parts on this unit: 1 - SMA connector for antenna #3 broke off; piece ended up embedded in antenna housing 2 - For antenna #2 the part just before the SMA connector that's soldered to mainboard (labeled CON 38; thru-hole connection) was off solder-pad, it's pins...

Would an iptables rule-set be better option?

Greetings all. I've been testing motion capture on a grey-market Hikvision cube wired to a non-WAN connected Asus router. Images are written to usb drive on router. I want to connect it to main router (R7800 w/ Voxels latest) in order to continue capturing motion AND receive email alerts upon...

Got it successfully flashed with older tomatousb firm. Good thing too since it seems jtagging may not have been possible.

I have tried RT-N66U_380.70_0. Haven't tried any earlier release. I've resigned to jtaggig it

Been doing that also when trying to flash via that interface.

Yup, via WPS & power button combo prior to, and after flash

I've been able to TFTP various firmware onto device, but nothing changes; still eternal boot loop. Unable to connect via telnet or any other protocal other than http to CFE interface. "flash -noheader : flash0.trx" requires access to serial console and I have no cable, nor even looked up...

The CFE is still AC66U, and won't even take that firmware

I have been shutting it down via power switch and pulling AC. Eventually I regain CFE web interface to do it all over again. No joy yet.

Did that once again yesterday, uploading official ASUS firmware and came back hours later to see message on interface asking to wait for reboot. Left it overnight, pressed continue this morning only to have CFE page load again. What would or should be "correct soft" since every one I've tried...

Of the few times I thought I had successful flash via CFE, page displayed wait for reboot. I guess 1/2hr wasn't long enough. Also, just noted on last attempt that recovery utility app rejects official ASUS firmware ("unnamed file not found", or words to that effect)

This n66u was mistakenly flashed with latest ac66u firmware. It took the flash well and, while I didn't set it up, it appeared operational. I then tried to flash 374.43_49E4j9527 via web interface and ended up in boot loop. Since then I've tried 374.43_47EBj9527, big and mega DD-WRT releases...