Recent content by obsanity

Did an update today. Got GT-BE98 Pro in AP mode running with three ZenWiFi BQ16 Pro in mesh. It asked for a manual reboot at the end. Web interface is now on DHCP instead of my fixed IP I setup. The previous mac address is not showing up in my gateway. When trying to log in to GT-BE98 Pro on a...

Decided to downgrade because of all the pain. Could not add newly purchased TP-Link matter light plugs as well as a lock Gateway I just got. No matter what setting I choose it would just not want to connect to Wi-Fi. As soon as I downgraded all devices connected within seconds and I was able to...

Posting another update. When I have to reboot or change Wi-Fi settings it takes a long time for everything to come back online. I'm estimating 30 minutes or so. Obviously not normal. Here is my setup: ASUS GT-BE98 Pro with this firmware ASUS ZenWiFi BE30000 with 3 nodes in AI Mesh network...

After leaving it overnight, all devices seemed to connect now. I'll monitor and report if there are further issues.

Install it today and I regret it. All my iOT devices don't connect anymore. What a nightmare. Can I flash back?

Sorry, ignore my message. I got the 98pro

Install it today and I regret it. All my iOT devices don't connect anymore. What a nightmare.

Why would they then say: "This setting can be found under "Network > Main Network"

"3. Improved AiMesh Backhaul Compatibility." Weird, I don't see that setting. Anyone else?

Has anyone had issues with firmware check not being able to access the servers? Since the November update it's been doing that. I see the December update flashing icon and I can tap update but when I try clicking check for updates below it says it can't connect to Asus servers.

I'm running the load balance on the pro and it's working fine. However, when one service is out, unless I unplug it manually, it drops half of my devices from Internet. I'm running 1:1 load balance. I wish they fix this. Clearly the ping settings to make sure connection is live is not working. I...

It looks like 320Mhz is just not working correctly on the 2nd 6Ghz band. Forcing it to 160Mhz stays on 160Mhz. I've tried disabling PCS as well as any auto setting and nothing keeps it at 320Mhz. It keeps dropping it to 20Mhz (lame). There is nobody around me using 6Ghz frequencies anywhere...

Updated just today and noticed 2nd 6Ghz band on 20Mhz bandwidth even though setting is at 320Mhz. Rebooting fixed it but it's back to 20Mhz again. Seems like a bug. Also, when setting up MLO it now allows only one SSID. Message comes up that you have to turn off MLO on the other of you try to...

FYI, the problem appears to be fixed with the latest firmware. I'm finally able to specify LAN2 for my 2ndary WAN port for the dual WAN setup. This frees up my 2nd 10G port which I use for my 2nd switch.

It was probably because you chose both WAN ports for your dual WAN configuration because those are the only two ports that will work with dual WAN. I'm running it like this because even though you can configure one of the LAN ports as one of your dual WAN setup, the router just doesn't recognize...