Recent content by oldwood

Hi Merlin, It was operator error on my part, as I am sure it is more often than not. I had Redirect Internet traffic through tunnel set to, no on the client I was connecting to for some reason. When connecting with 386.2_6 it would connect and show my VPN IP but when I update to 386.3_beta 1...

Well a bit of a brain fart there, I flashed the wrong Beta ;( When I go back to Beta 386.3_beta1, I get the same problem. Accept DNS exclusive or relaxed makes no difference.

I re flashed the Beta, and it seems to work fine now. The last time I flashed it, the first time I started the client was through the VPN director tab, so I don't know if that had anything to do with my problem. Thanks for your help.

No 172

It says it is connected, but it does not connect because my ISP address is still shown when I check for my public address. Also, when it is working in the client tab it shows both the local and public address, but in the beta it shows the local and says public in unknown.

Yes

I should have mentioned I am not using any rules, so there is nothing listed there.

The VPN director page shows a list of the clients. I was able to start a client through that page also.

When back to 386.2_6 and VPN hooks up no problem.

Dirty update from 386.2_6. Open VPN client says connected, but it is not. When I check my IP address, it shows my ISP?

Thanks that makes it much easier. Just a few AC routers then the rest are the new AX platform. By my reckoning they are all HND (home networking devices) ;)

Thanks for this, look like lots of good info. Gerry

"You should familiarize yourself with add-ons and how Merlin and scripting works." Is there documentation on this subject I can review? "Email setup on the router goes only through your provider to whatever addresses YOU SPECIFY. You set these up in Diversion (again via amtm) and we use the...

It seems to be an impossible thing to confirm on the router interface? The "newer Broadcom-based routers" is also a term that I can not confirm on my router. The RT-AC3100 is Broadcom based and is still sold in some locations, but I don't see anything indicating it is HND. I suspect it is not...

Hi, that is good to hear. I think I will give it a go. Can you direct me to instructions for scripting on the router? I have a USB 2.0 thumb drive I am using for the monitoring data, but I have a USB 3 thumb drive I could use for scripts. In the admin page there is a setting for USB mode. Does...