Recent content by outlaw78

Ok this show's over 32 this way. Is there a way to clear this as the GUI only shows a few set and won't let me make any changes, even back to default....

But I don't have any where close to 32 set.

Don't know if its the right place to post a bug, but this version on the AXE-16000, while in Adaptive QOS and trying to drag down the "Highest, High, Medium, Low, Default, etc" buttons, I get a window message box that pops up, "Max Limit:: 32". Dirty Flash from 102_5

I get the concept of what it does, but when it comes to public Wi-Fi and Windows, does any settings in windows make a difference? For example, my wife and I are in the same hotel, connected to the same Wi-Fi and we can not see each other's PC to share files. Our connection is set to allow...

I have an old WD MyBook LIve. I can connect to its shares via IP (and netbios name by editing the host file) over the VPN. However, when I try to connect to its UI over the VPN, I get "You don't have permission to access /UI on this server.". I can access the router UI just fine over the VPN...

I think it may be in the firmware, as being on 3004 merlin, I did not have the issue described above. Not saying its in Merlin firmware specifically, but in general.

I've been having similar issues as well. Not full drop outs but slowdowns on both 5ghz bands and 6e. On 6e, I get a several seconds on BLAZING fast speeds of 950mbs+ then it tanks to 500-600 and holds steady. Packet loss included. Started around the time I upgraded to 3006. I've factory...

I'm just using the RT-AC5300 as a media bridge to hardwire my theater room devices. Is it better to put on stock firmware or will EOL merlin be ok in this situation since its just being use as a media bridge and not as a main router?

Quick question, if I'm on 3006.105.2_beta3, is there any changes that warrant 3006.105.2?

Forgot my router model. I apologize. Its axe16000

i just saw the beta 2 released. Downloaded and it had no effect. probably going to factory reset next weekend as the post above suggested.

Upgraded from 3006_102.4 to 3006_102.5_beta1. Cpu temps went from 60s on 102.4 to 80s on 102.5_beta1. Side note, I had high temps in the 80s on 3004 firmware as well until I upgraded to 3006. Cpu usage is low. Never more than 50% when I'm watching the usage. Rebooting had no effect. Any...

Is one going to be able to downgrade back to 3004 once 3006 has been installed?

Could the switch be "flipped" and a disclaimer added that the ROG Gui isn't supported or maintained and use at your own risk like you did with AI-Mesh back in the day before enabled that in your builds? I realize this could introduce breaking bugs. It was just a thought.

I get that. But I also read somewhere it's just a "switch" to enable the rog gui. I read in from a previous firmware update