Recent content by palmoyas

I'm in bridge mode, so prioritization is inaccessible/grayed out/disabled. Also, I seem to get the fastest speeds with Node Steering disabled, but Client Steering enabled.

Is the -66 of the .14 node that bad? I can't really move it any farther than a couple of feet without moving it into another room that will present much more interference.

Thanks. I essentially got the MR9000 for free so I'm "stuck" with it. My Xfinity service is only 200Mbps anyway. I think I have it dialed in pretty well at this point (yes, I know the 1.22 node is daisy-chained). My AP fluctuates between the low 70s and upper 60s on the 1.16 and 1.22 nodes...

If anything, I could use the MR9000 in bridge (AP) mode as the parent mesh node, wired directly to the Netgear, which would still be operating as my router (but with the radios turned off). I could then move the current tri-band Velop parent node out as a satellite/child, replacing one of the...

Wondering if this upgrade is worth it (or if it's even an upgrade). I was able to pick up the Linksys MR9000 for $54. What performance improvements, if any, could I see? Do any of these matter: Dual core to quad core? 3x3 to 2x4? AC1900 to AC3000? I'm getting 250Mbps service from Comcast...