What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by pat.ibulaire

  1. P

    How to get the gateway of a route inside a jffs script

    It works, Fantastic thank you! Then I can solve my problem with the selective routing, killing the route pushed by the server and replace them with the good gateway value...
  2. P

    How to get the gateway of a route inside a jffs script

    Hello Everybody, here is a simple question about scripts : My ip route list output is : 74.131.173.17 via 192.168.0.1 dev eth0 192.168.0.1 dev eth0 scope link 74.131.168.128/27 dev tap11 proto kernel scope link src 74.131.162.132 192.168.0.0/24 dev eth0 proto kernel scope link src...
  3. P

    cannot connect to my openvpn server when my vpnclient is running

    I managed to succeed manually, using the selective routing script, but I have trouble extracting the gateway address from "ip route list" see my post http://www.snbforums.com/threads/selective-routing-with-asuswrt-merlin.9311/page-19#post-191504
  4. P

    Selective Routing with Asuswrt-Merlin

    Hi everybody this script look very good because it works with both a vpnclient and vpn server running on my Merlin routeur. I'm trying to adapt this script to my situation but I have a little problem : the tun_ip I should use is not the inet addr given by ifconfig but the gateway pushed the...
  5. P

    cannot connect to my openvpn server when my vpnclient is running

    Yes i tried but it did not work. A ping to 10.8.0.1 from the router interface result in 100% lost packets with the vpnclient1 runing or not. In fact I think the vpnserver packet send to the the listening port 192.168.0.10:1194 does not reach their target. Edit a ping to 192.168.0.1 ans...
  6. P

    cannot connect to my openvpn server when my vpnclient is running

    I noticed that is the route below that prevent the connection when the vpnclient1 is running 0.0.0.0/1 via 74.131.169.129 dev tap11 if I delete that route I can connect to o the vpnserver but indeed traffic from lan is not routed through vpnclient1 anymore and just go nowhere
  7. P

    cannot connect to my openvpn server when my vpnclient is running

    in fact ifconfig does not show any ip associated to tap21 it shows UP¨BROADCAST RUNNING PROMISC MULTICAST
  8. P

    cannot connect to my openvpn server when my vpnclient is running

    Do you mean doing something like : ip rule add from 10.8.0.0/24 dev tap21 table 100
  9. P

    cannot connect to my openvpn server when my vpnclient is running

    Thank you very much Merlin for your reply, the problem is that I will be on leave in a few days and I don't want to take the risk to install a new firmware version and having to reconfigure everything with such a short notice. I was under the impression that adding a couple of routing rules...
  10. P

    cannot connect to my openvpn server when my vpnclient is running

    Hello everybody, - I have my asus/merlin router running vpnclient1 (tap11) which connect to an external vpn server - All internet traffic is routed through this vpn client by default when it is running - I have my asus/Merlin router running vpnserver1 (tap21) which listen on some WAN port...
See more
Back
Top
✖