Recent content by pfuller88

I have a similar setup. A dedicated pfsense box with one ethernet (VLAN) going to ASUS router in AP mode. This ASUS router hosts several other ASUS routers in AIMesh. When you change your ASUS router to AP mode it might clear the Mesh, if it does, as mentioned above, just setup again.

smooth upgrade on axe16000

I too am on Bell Fibe internet. When they installed they brought fiber cable right to the house. They recently upgraded me to from 150 to 500. I have had no issues. SImilar to above, I needed lan to wan (bell to AC5300) and pppoe setup on my Asus ac5300. TVs remained connected to Bell hub.

I switched to pfsense and a QOTOM box, intel 5 series chip, 8GB ram (way more power than pfsense needs) about 6 months ago. I also use my Asus routers in AP mode and can VLAN them to isolate networks. I really like the VLAN setup to isolate (or not) with custom firewall rules that are very...

Hi, I updated my ac5300 to 386.5 several weeks ago. I notice a ton of the below log entries, the mac address changes in the log, below is a sample of one of the macs (not always the same connection). I searched the forum, I see a few others with this, did not see a reason or solution? I am...

Alpha 1, 386.4 installed yesterday on ac5300 with ac68u AiMesh. All is stable so far. dirty upggrade.

Thanks, I'll investigate further.

I have one DHCP client that renews DHCP every 5 minutes. All others (30 or so other leases) work fine with the LAN DHCP renew set to 7 days or, 604800. I have tried changing lease time to 1 day and the one client still renews every 5 minute. Log entries below. I tried setting a staic IP and...

dirty upgrade from 2_6 to 386.3 beta on ac5300. All seems fine. I'm using Yazfi with one 5G guest dedicated to NordVPN client. All working as expected and VPN DIrector shows rules correctly.

Have a look at this link... https://www.snbforums.com/threads/rt-ac5300-performance-security-guide.45710/#post-393463

I have the ac5300. I initially moved to 361 beta 1 a few weeks ago and had many issues. reverted back to 384.19 which is stable (did a factory reset to revert back). Today I dirty flashed to beta 3. So far all looks good. I have 25 IPs on the network, some ethernet, some on each of the 3...

I tried both ways

I have a RT-5300AC and RT-AC68U. Factory reset both from 384-19 to 386 beta 1. Removed USB and clean start on both. Several issues required me to revert back to 384-19... 1) I could not Aimesh the routers, tried 4 or 5 times - 5300AC could not find AC68U. When I revered back to 384...

updated 5300 to 16 beta 1. 2.4 network was dropping clients and iphones could not connect . 5.2 wifi worked fine. Tried a few changes to 2.4 wifi settings, no change. went back to version 15 and working fine. it was a dirty flash.

Updated my AC5300, no issues so far.