What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Philsburry

  1. Philsburry

    Solved Guest Wifi (index2) on same primary subnet - What & Why?

    It does not matter whether it's 2.4 or 5ghz as long as it's the very first Guest network that's been created?
  2. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    sfx2000, I appreciate your input. I understand most ppl do not require vlans, but for my case I do as I'm running a test domain environment. It's funny that you mention putting things down on paper, as I'm doing that right now to see where I've messed up. (Keep it simple, and build it up...
  3. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    Update: I went ahead and purchased the Netgear R7000 today. The issues I had are resolved now after upgrading to TomatoARM from Shibby. One thing though after upgrading to the Tomato firmware, the WAN to LAN speed lower. I was able to get 600mbps +, now I'm only getting an average of 300...
  4. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    was hoping to avoid that...thanks for your assistance!
  5. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    No, no issues when I'm connected directly to the wireless router ethernet port. I do have vlan tagging, but it's all on the switch side. The wireless router does not have that ability to assign vlans. (Well...it does, but it's for the ISP and IPTV/VOIP). On the previous wireless router, I...
  6. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    If I plug this PC into the switch, I can access my servers/nas/other PCs on the network. (But just can't get the net.) :( Can you explain what you mean by Active VLANs? On the switch I have the following created when I created the vlan interfaces: Destination IP Address Mask Protocol...
  7. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    Hi SEM, thanks for your prompt response. I have some comments/questions: I'm not sure what you mean by 'route over loopback'. Did you mean don't create the static routes on the router to point to the .254 addresses? I don't have the ability to create vlan interfaces on the wireless gateway...
  8. Philsburry

    Wireless router and layer 2 smart switch = no internet.

    Hello, I am wondering if someone with routing/vlan/switch knowledge can assist. My setup: Synology RT1900AC wireless router HP 1910 24port switch - 3 vlans created on the switch. The switch takes care of the internal routing as I understand it. 10.3.2.0 10.3.6.0 10.3.8.0 - 1 static route...
See more
Back
Top
✖