Recent content by pmcarrion

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. pmcarrion

    VPNMON Block IPv6 on devices routed through a VPN

    I have IPv6 enabled on my network, but this causes an IP-leak on devices routed to a VPN on the router. The solution would be to disable IPv6, but I would have a significant performance hit as my ISP is IPv6-first and is much faster over IPv6. It would be great if VPNMON had an option to block...
  2. pmcarrion

    Notifications when device goes online/offline

    Hi guys, I currently use a Fingbox to get notified when devices go online/offline, but the manufacturer discontinued it and it stopped sending notifications. Is there a way to get notified when a device goes online/offline? Perhaps a script or add-on? Thanks.
  3. pmcarrion

    Voxel Custom firmware build for Orbi RBK50/RBK53 (RBR50, RBS50) v. 9.2.5.2.31SF-HW

    @Voxel Hello, I'm trying to install ctrld on my RBK50, but the binary and the config files get deleted on each reboot. Is there any folder on the Voxel firmware that’s writable and persistent between reboots? Here's the GitHub issue requesting support for Voxel Firmware. Thanks.
  4. pmcarrion

    from XVortex to ASUSWRT-MERLIN on an ac1900

    FreshTomato is the best firmware for the R7000.
  5. pmcarrion

    Solved No Swap file detected

    I followed your guide and it worked! You're right, this was a USB drive issue. I reverted to USB 3 and used another drive. Everything works as expected now. Everyone should avoid using SanDisk Ultra Fit USB drives for this purpose. Thanks, @ColinTaylor @L&LD @glens @JGrana!
  6. pmcarrion

    Solved No Swap file detected

    I switched to USB 2 and still get this error when creating the swap file: Nov 16 20:48:18 kernel: usb 1-2: USB disconnect, device number 2 Nov 16 20:48:18 kernel: sd 0:0:0:0: [sda] FAILED Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK Nov 16 20:48:18 kernel: sd 0:0:0:0: [sda] CDB...
  7. pmcarrion

    Solved No Swap file detected

    I repeated the whole process to get the exact error from the system log: 1) Formatted USB drive using amtm's fd command. Success. 2) Installed Entware using amtm's ep command. Success. 3) Created a 4GB swap file using amtm's sw command. Failed. Here's the system log for the swap file creation...
  8. pmcarrion

    Solved No Swap file detected

    I had reformatted the drive without a dash in the label (1 partition, ext4, journaling on, and labeled). Here's the output after the creation of the 4GB swap file: Swap file created and activated: /mnt/ASUS128USB/myswap.swp No swap file found, reference removed in /jffs/scripts/post-mount...
  9. pmcarrion

    Solved No Swap file detected

    Dashes seem to be OK. I get this output: root@RT-AX88U:/tmp/home/root# cat /proc/swaps Filename Type Size Used Priority It doesn’t show any swap files.
  10. pmcarrion

    Solved No Swap file detected

    My RT-AX88U runs Asuswrt-Merlin 3004.388.4. I plugged in a SanDisk 128 GB USB flash drive into my router, enabled JFFS, ran amtm, and formatted it using the fd command (1 partition, ext4, journaling on, and labeled). I also installed Entware using the ep command. The router works, the USB drive...
  11. pmcarrion

    Release Asuswrt-Merlin 388.1 is now available for all supported Wifi 6 models

    DoT doesn't work with Control D on 388.1 on my RT-AX88U. I couldn't get an Internet connection from any device using the router's DNS server. Devices and browsers using DoH were unable to connect either. The only exception is my laptop using dnscrypt-proxy. I reverted to 386.8 and everything...
  12. pmcarrion

    Disable IPv6 when connected to VPN

    Only computers allow this, so most devices would be left out. I'll test this. Thanks.
  13. pmcarrion

    Disable IPv6 when connected to VPN

    The script didn't fail, but it made my network sluggish and IPv6 wasn't blocked. I think this would work well on a desktop client. You're right, I'll just disable it until the router's VPN client supports IPv6. I noticed this with some IoT devices that stop working all of a sudden...
  14. pmcarrion

    Disable IPv6 when connected to VPN

    Thanks, but it didn't work. Here's the log: Aug 21 20:50:18 rc_service: httpds 1565:notify_rc restart_vpnclient1 Aug 21 20:50:18 ovpn-client1[2613]: event_wait : Interrupted system call (code=4) Aug 21 20:50:18 ovpn-client1[2613]: ovpn-route-pre-down tun11 1500 1624 10.117.250.25 255.255.254.0...
Top