Recent content by princi

Brand new to Control D - subscribed and setup my Merlin router as an Endpoint Used the SSH command to install Control D on the router Can't see any evidence in the Merlin WAN settings of a DNS service being used. Still configured for ISP DNS. Is this correct? Or should I be selecting Control...

… but won’t last very long and will eventually fade away. (Thermal fax paper for anyone under 50)

Anyone able to get 3 concurrent WireGuard sessions on this router? I've tried it on other routers running 3.0.0.6 and always get the msg about it being limited to 2 - pls disconnect one before trying to connect another one. I used to run two ASUS routers to get 4 concurrent WireGuard sessions...

He saves a lot on heating…. All that radiation! I run 3 routers for 12 clients because of my 6 tunnels!

No 3.0.0.6 branch for the AX88U then. Check update not showing any new version. That means I need to download & unzip. Bit over this, if I’m honest.

No release version for this model yet? I use the 3.0.0.6.102 branch on other routers and I’m very happy with it.

A more interesting question would be whether anything older than the AX6000 will be getting 3.0.0.6

I doubt it. I updated just minutes ago from the GUI. It couldn’t have been smoother. I didn’t even have to reboot. Errr, guys, this is an AX6000 thread.

Correct I wouldn’t want an ACMA van driving past your place with their antenna scanning the local frequency spectrum - and detecting something unauthorised. They can issue a fine. ACMA = Australian Communications and Media Authority

The reason to change your country setting to Australia is not so that you get some sort benefit. You might be getting good speeds but what about your neighbours? You’ll most likely be “stepping on their toes”, using frequencies that are not authorised for use in Australia, and creating problems...

Yes.

Check whether NZ Wifi frequency allocations are the same as AUS - shouldn’t be too hard. AUS wifi frequencies are supported - user selectable.

Be advised: Be noted doesn’t exist. Note, Nota bene or Be advised. There is no need for pleasantries such as please - no obligation. 1337 🤣

I will wait for the next beta and try the guest network pro as a VPN tunnel. Recently went back to latest stock. If that “other” VPN network is in addition to the two WireGuard tunnels I have setup in VPN Fusion - that would be useful. Personally, I don’t see the point of that VPN Pro network...

Would it be possible to create a VLAN for a specific VPN tunnel and route all that traffic through the VLAN? (most likely yes) … and then create a WiFi interface linked to that VLAN? By interface I guess you mean IP range. Even better would be creating an SSID for that VLAN so that all tunnel...