What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Quentin

  1. Q

    Best practice for Entware re-install

    I only got around to this again now, but yes, that is the route I ended up taking, and it worked.
  2. Q

    Best practice for Entware re-install

    My Entware installation appears to be borked. When I try to execute any command, I see a screenful of garbage characters, followed by "Filename too long". This problem also prevents updates via amtm or otherwise. What is the best sequence for stopping any running services that may depend on...
  3. Q

    Slow wired up-link and lower WAN throughput from router than from connected devices

    Just wanted to report back in case someone else has the same problem. I upgraded the firmware, powered down everything then followed the power on sequence you described and now I am getting full symmetrical up/down speed.
  4. Q

    Slow wired up-link and lower WAN throughput from router than from connected devices

    Thank you for the detailed response. I do not have QoS running, nor any other services. The older firmware version is not installed for any particular reason; it has just been a while since I updated. Will be sure to update first thing, and will also try the reset sequence you suggested if...
  5. Q

    Slow wired up-link and lower WAN throughput from router than from connected devices

    I have an ASUS RT-AC3100 running Merlin 384.10_2. My internet service was recently upgraded to symmetrical Gigabit fiber. When I connect my laptop directly to the incoming Ethernet link from the fiber switch, I measure throughput of around 930 Mbps up and down. When I connect the link to...
See more
Back
Top
✖