Recent content by ressac

tried to run iperf test again, but this time in reverse mode, and get only about 250 Mbps

my setup is ONT <-PPPoE-> AC68U(using Merlin, 800Mhz cpu, NAT acceleration CTF (Cut Through Forwarding) is enabled.) ISP speed is 600Mbps I did basic test with iperf, run iperf server on PC connected to ethernet and mbp 15” 2016 connected to wifi(ac 5gh) transfer speed was about 650Mbps All...

ok, it's good to know, but doing this thing somehow i get page where i were able only to reset nvram and upload new firmware anyway i think i found what was causing this issue i had, Traffic Analyzer - Statistic, what a surprise... on the beginning it wasn't causing this type of problem but...

i did soft reset from admin panel, and also i did before hard reset pushing reset button. i also tried 30-30-30 reset getting access to console where i did nvram reset(erase) or something like this. before i never tried scheduler reboot, maybe it always was like this? another day i was googling...

i'm still having this problem, i also did update to 380.62

lol :) i just figure out what i wrote before :)) so wifi (ex wife) is not working, it's not about channel or something that must look with configuration, it's like wifi module dont even start. i had attached screen and you can see clearly that MAC on this screen is zeros... sorry for my...

i had set Reboot Scheduler on 5am every day, so sometimes wifi doesn't work after those reboots it might be only 5ghz not working or even both 2.5 and 5 i did tried also factory reset.

thx

after update fw to last version i have problems with Wireless MAC Filter i can't delete old fields also i can add new and delete new one, but no old you can see more info on screenshot how i can delete old fields? without reset fully router ?

safari and chrome

Weekly Traffic size is increasing always if i change Daily/Weekly/Monthly back and forth, i mean it starts at 10gb and if a go from daily to weekly it goes to 20 gb and then if a go back to daily it's not 10gb like it was before it 30gb

do you even read first post of this thread?

please mention that stationary elliptical bicycles (at leaste with magnetic resistance) create interference too

ok, sorry for my english all i'm trying to say that wifi is working good, except when it is WAN<-->WIFI here is quote form this thread http://forums.smallnetbuilder.com/showthread.php?t=14586 this is my problem: thx for patience

ok i've got 99 Mbps on 5ghz with only N, by turning off "Universal Beamforming" but i'm still stuck with low speed on 2.4ghz only WAN, i mean internal ftp on 2,4ghz gives over 100Mbps but when i'm using WAN i cant get more than 50-60 Mbps why speed is slow when i'm using WAN via WiFi...