What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by ripdog

  1. ripdog

    IPv6 on a RT-AC68U

    I have a similar issue on Orcon NZ. I'm testing IPv6 for my ISP. It works fine with the supplied router, but no signs of life from my ASUS router - the RT-AC66U. I have a fibre connection, and receive IP via DHCP, tagging packets with VLAN10. From the network engineer who set me up to test this...
  2. ripdog

    My alternative to vi- what is yours?

    I fail to see the problem with vi. Spend 10 minutes learning a few basic shortcuts and vi beats the pants off nano. I'm nowhere near an advanced vim user, but it drives me nuts when I find myself back in basic editors like nano.
  3. ripdog

    wan-start userscript not working

    Thanks to all in this thread for finishing debugging when I was away! Can confirm that the script works fine with a delay.
  4. ripdog

    wan-start userscript not working

    It's not running at all. It works fine when i run it myself.
  5. ripdog

    wan-start userscript not working

    Thanks, but as you can see the execute bit is set for all the scripts.
  6. ripdog

    wan-start userscript not working

    Hey condor, could you post the output of ls -lah in /jffs/scripts? Just to make sure it's not an ownership/permissions issue.
  7. ripdog

    wan-start userscript not working

    Unfortunately my optimism was misplaced. All /bin/bash's were replaced with /bin/sh, and ./wan-start works now, but script still fails to fire when wan starts. I added logger lines to more easily tell when the script is run, but no luck. Would love any additional ideas on getting this working.
  8. ripdog

    wan-start userscript not working

    Oh wow, it's really obvious in retrospect. Thanks a lot, mate! Works good from command line now, should work on connection too, let's hope. Thanks again!
  9. ripdog

    wan-start userscript not working

    So I'm trying to get my router to automatically update my IP with unotelly when a connection is established. I can't figure out why it doesn't work, though... admin@router:/jffs/scripts# cat wan-start #! /bin/bash touch /tmp/000wanstarted #sh /jffs/scripts/tunnelupdate.sh sh unotelly.sh...
See more
Back
Top
✖