Recent content by rlw6534

I'm pretty sure that the channel cleared message means no DFS conflict detected. It's the same message I received when 160 MHz was working.

No difference.

I'm having the same issue. 160 MHz will work for a minute or so and then switches to 80 MHz. Kinda like 2.4 GHz when set to 20/40 never goes to 40 MHz. Even selecting 160 MHz only gives the same result. DFS shows the channel is cleared for 36/160. It worked on previous firmware (Asus and...

This may not be beta related but I have been getting this in the log for a while now on my AX86U. I flashed the beta to see if it was resolved, but no: Jun 18 07:41:03 acsd: acs_candidate_score_intf(1108): eth7: intf check failed for chanspec: 0xe832 (36/160) Jun 18 07:41:03 acsd...

When I installed pixelserv-tls it also installed libopenssl and zlib. Shouldn't that have taken care of that?

Yes, it seems to work if I install Diversion and copy the certs, uninstall Diversion, reinstall pixelserv-tls and restore the certs generated by Diversion.

OK. The only glitch I had was the cert creation. I had to use the alternate method you provided.

I'm not sure Pixelserv-tls is working correctly for me. I have imported and trusted the cert and even rebooted the router and my MacBook. With Diversion "slh" normally increments with browsing. Are you seeing the same? slh 0 # of accepted HTTPS requests slm 6 # of rejected HTTPS requests...

Thanks! I have not seen any certificate/trust errors while browsing (as with Diversion), so I was a bit confused. Actually, I still am TBH... Easy enough to trust the cert, though...

Playing around with this today. Is it best to trust the certificate on clients (for best performance) or does it not matter at all?

Thanks! That explains it. I thought maybe I had messed things up... ;)

do-ipv6 is set to no. I don't remember seeing these errors before, but maybe I overlooked it.

I'm not using openvpn. I have ntpmerlin, scmerlin and unbound installed, otherwise stock Merlin.

This is probably a noob question, but is it normal to get these errors when updating unbound? IPV6 is not enabled on my router (AX86U): [1645651142] libunbound[29314:0] error: udp connect failed: Cannot assign requested address for 2001:500:12::d0d port 53 [1645651142] libunbound[29314:0]...

It might help if you could describe your setup. Multiple routers and multiple modems? Are the two networks totally separate? Or two routers going through one modem, mesh, etc?