Recent content by Robert Tickle

Performed a dirt (make that dirty) update from 3004.388.6 to 3004.388.6_2 on my three RT-AX86U network. All routers rebooted and all devices reattached normally. Been running fine for three days now.

Did a dirty update from 3004.388.5 to 3004.388.6 on the main router and two nodes. That was three days ago. New firmware installed without a hitch. Router and nodes rebooted fine. All forty three network clients reconnected perfectly. System has been rock solid. The GUI even seems a bit...

I recently purchased a Canon GX1020 printer and connected it to my 2.4ghz network. All of my laptops are connected to my 5ghz network. My laptops cannot “see” the new printer unless I connect them to the 2.4ghz network as well. My old Brother printer didn’t have this problem. Is there some...

After uninstalling and reinstalling Skynet a couple of times, the Skynet statistics tab in Asus-Merlin started working again.

I used the uu command to force amtm to update to v4.1. Then I updated Diversion to v5.0 using SSH commands as instructed. I noticed that uiDivStats is disabled, as you said it would be, but now Skynet is no longer showing me statistics in the ASUS GUI. Is Skynet v7.4.6 also not compatible...

Neither, I selected e to exit.

This is what I get when I run the ep, 3 commands: Seems to be a problem.

I am trying to update to amtm 4.1 when the hang occurs. I don't think I have any scripts installed after YazDHCP. This is what I see when I launch amtm: Will the next release of Asus-Merlin contain amtm 4.1?

When I use the u to update option in amtm, it seems to hang. What could be causing this?

Dirty upgrade from 3004.388.4 to 3004.388.5 on router and both nodes. Smooth sailing all the way.

I had issues when I did a dirty flash from 386.7_2 to 3004.388.4_0 on my AX86U. Ended up doing a factory reset and reconfiguring from scratch. Now my network is the most stable its been in the three years I've had this configuration.

They are indeed set to "notice" and "debug". Thanks again for your help. You are an asset to the community.

Apparently I DID change my Syslog levels. My "Log only messages" was set to "notice". When I changed it to "debug" I started getting results in the Skynet tab. When learning about how to install Skynet, I don't recall reading anything about Syslog levels, but I could have missed it. Thank...

I have not change syslog levels. admin@asus:/tmp/home/root# ps ww | grep logd 1438 admin 3424 S /sbin/syslogd -m 0 -S -O /tmp/syslog.log -s 256 -l 4 1440 admin 3424 S /sbin/klogd -c 5 8607 admin 5972 S grep logd admin@asus:/tmp/home/root#

I've uninstalled and reinstalled Skynet several times. In the GUI it still reports "No Data to Display" after running for 24-hours. Below is what I get when I run your code: admin@asus:/tmp/home/root# ASUSWRT-Merlin RT-AX86U 3004.388.4_0 Mon Aug 21 19:34:20 UTC 2023...