What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Robert57

  1. R

    RT-BE88U DNS-over TLS

    I have found the problem. AdGuardHome is not compatible with DNS-over-TLS. AdGuard had also put itself in a continuous loop. I removed AdGuard and now DNS-over-TLS works. Thanks again to everyone who helped me
  2. R

    RT-BE88U DNS-over TLS

    So I don't know if my provider blocks my upstream IP. I have unblocked port 853. The provider modem is switched to bridge. I get the IP address directly on my router
  3. R

    RT-BE88U DNS-over TLS

    I'm concerned with the principle that the product should do what it claims to be able to do. Of course, I now have the same opinion that it makes no sense to send two controls on their way at the same time. I have already switched DNSSEC off. Even if this is switched off, DNS-over-TLS cannot be...
  4. R

    RT-BE88U DNS-over TLS

    So: Checked everything again, switched off various activities and tested again. Did not help. I will probably go back to the factory settings and then try to set up DNS-over-TLS first. I really don't feel like doing this, but I will try again.
  5. R

    RT-BE88U DNS-over TLS

    This may well be that this makes no sense. But I don't see how this can have an influence on an input that should therefore not be activatable........
  6. R

    RT-BE88U DNS-over TLS

    Thanks for pointing out the difference. I will check that too. Yes OK I have pressed after the corresponding data. Have you also set up DNSSEC in addition to DNS-over-TLS?
  7. R

    RT-BE88U DNS-over TLS

    Thank you all for your help. However, I don't want any more third-party programmes on my network. At least I have an encrypted environment. Maybe it's just me having the problem with my RT-BE88U router
  8. R

    RT-BE88U DNS-over TLS

    Thank you all for your help. However, I don't want any more third-party programmes in my network. At least I have an encrypted environment. Maybe it's just me who has the problem with my RT-BE88U router
  9. R

    RT-BE88U DNS-over TLS

    I get the following answers: dsnpriv_enable=0 dnspriv_profile=1 the dnspriv_rulelist is output with the data from quad9.net. dnspriv_enable is set to 0, which means it is not active. I have reset and reinstalled my router. There has been no change in the situation
  10. R

    RT-BE88U DNS-over TLS

    Perhaps DNS-over-TLS is also active. Do you know how I could check this?
  11. R

    RT-BE88U DNS-over TLS

    I currently have Firefox as my browser. Switched to Windows Edge and have the same reaction. I'm also not really sure if this could be a browser issue as the DNS over TLS should be a direct command for the router
  12. R

    RT-BE88U DNS-over TLS

    That's what I did (see first picture) The address of Quad9 is included in the list
  13. R

    RT-BE88U DNS-over TLS

    Thank you very much for your support!!! I'm not sure if it's set up correctly for me. The problem is that I have set it up according to your instructions. (see appendix) then also pressed Ok at the bottom. However, when I leave the WAN area and then return to the WAN area, DNS data protection...
  14. R

    RT-BE88U DNS-over TLS

    Addendum: Use Asus Merlin
  15. R

    RT-BE88U DNS-over TLS

    Hello everyone I am quite inexperienced in the router area, can someone tell me how to set up DNS-over-TLS on my router. I have to say that I have already activated DNSSEC. Thanks for the advice in advance
See more
Back
Top
✖