Recent content by Ron Rossi

  1. Ron Rossi

    Real-time Traffic Monitor tab reverts to Wired at every sample...

    Folks, I am using RT-AC66U since Nov 2015 currently on 380.59. When I use the real-time traffic monitor I cannot monitor any of the tabs other than "wired" for more than 1 or 2 seconds. If I chose 2.4G for example it will revert to wired at the first resample. When looking at the last-24hrs any...
  2. Ron Rossi

    Stumped by second 5GHz signal from RT-AC66U...

    Yes you are correct. THANKS!
  3. Ron Rossi

    Stumped by second 5GHz signal from RT-AC66U...

    I FOUND IT! You are right Merlin. THANKS. It is the new Google Chromecast puck. It connects as an N device at 72Mbps.
  4. Ron Rossi

    Stumped by second 5GHz signal from RT-AC66U...

    @jerry6, I should have included that info. Good thought. Guest is on 2.4G. No guest on 5G. I see both 2.4G signals as I would expect and with good MAC addresses.
  5. Ron Rossi

    Stumped by second 5GHz signal from RT-AC66U...

    Folks, Stumped by this one and not sure if it is an Asus thing, a Merlin thing, or what. In any case I ran "WifiInfoView" looking for WiFi signals and was surprised to find another signal on channel 161 (5.805GHz). It is shown to be originating from a strange MAC (FA:8F:CA:62:3D:C9) which is...
  6. Ron Rossi

    Asuswrt-Merlin 380.57 is now available

    Hi tony, Sounds similar to what happened to me with my SIP router. Even putting it in a DMZ did not work. I got around it by enabling SIP pass thru. Not a solution for you though. Some is bonked it seems. The problem persisted through a wipe to default also.
  7. Ron Rossi

    Asuswrt-Merlin 380.57 is now available

    I did just now verify that this behavior exists after doing a reset to factory settings (by the Admin panel reset to factory defaults button) and restoring previous settings via nvram-restore.sh. The good is that enabling SIP passthru seems to work. The bad is that forwarding UDP 5060-5160 will...
  8. Ron Rossi

    Asuswrt-Merlin 380.57 is now available

    I also see that SIP Passthrough needs to be enabled for SIP devices to work now. I just spent 2hr on the phone with my VoIP folks (1-VoIP...there US based support is great) trying all kinds of options ultimately proving there was nothing outside my network going wrong. While it is great SIP...
  9. Ron Rossi

    The rmerlin donation thread.

    Donated...thanks Merlin :)
  10. Ron Rossi

    Wireless and VLANS

    On my Asus I don't have the ability to monkey much with the VLAN settings. In the IPTV tab you can create an isolation. However it sounds like your question is how to have traffic from VLAN 5, 10, 15, & 20 (which I assume are unique to the downstream switch) get to the internet on your Asus...
  11. Ron Rossi

    Wireless and VLANS

    I am new here. It seems to set up a VLAN on ports 3 and/or 4 you can use LAN->IPTV tab. You probably knew that though. I have not figured out DHCP on the new VLAN nor bridging to it.
Back
Top