What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by Soap

  1. Soap

    Port 445 (Shields Up)

    Appreciate the responses Merlin. Thank you.
  2. Soap

    Port 445 (Shields Up)

    So if I flash the current stock firmware and probe the port it shows 'closed' but not stealth. If I re-apply the latest Merlin build it shows 'open' again.
  3. Soap

    Port 445 (Shields Up)

    Yea, I guess I need to do the obvious and just swap this one out. I do still have my old router (Netgear WDR7000v3) but I installed dd-wrt on it and put it in another part of the house and connected as a repeater bridge. I did already turn that router off to make sure my issues wasn't that device.
  4. Soap

    Port 445 (Shields Up)

    I don't see how it can be any of my computers in the house. I have powered them all down and pulled out a freshly loaded Windows 8.1 laptop and did a scan and I still get that same port as showing open. Again this was not the case until I swapped my old router out for the new asus.
  5. Soap

    Port 445 (Shields Up)

    Let me do some more digging and I will report back, the reason why I question this being something on my systems is because I passed the ShieldsUP! test right before I swapped out the new asus router. As soon as I re-tested it failed on port 445. This is why I am digging through the router. How...
  6. Soap

    Port 445 (Shields Up)

    Yea, I saw that mentioned on the website but I am not finding that on my system. I had checked Shields UP before I switched out my old router for this one and everything was good previously. As soon as I stood up the new router and ran it I got the port 445 hit.
  7. Soap

    Port 445 (Shields Up)

    I am running the latest Merlin build on an AC68R and when I ran Shields Up I notice that port 445 shows open. I am checking through the config pages and I don't see anything enabled that would cause this. Can someone help point me in the right direction please? Thank you.
  8. Soap

    QNAP TS-212 Question

    Yea, I spent the day fighting with FreeNAS and scrapped that idea. Ordered a QNAP TS-219PII earlier today instead. Researching now possibly installing BOXEE on the PC I was going to use, since DLNA sucks so bad...
  9. Soap

    QNAP TS-212 Question

    I appreciate the replys guys. I think I am now going to go the way of a DIY build with FreeNAS. I actually have an HTPC I had built a few months ago which I now am not using and should be a good candidate. It was built to be quiet and be power friendly. It is a Core i3 2100T processor with 4GB...
  10. Soap

    QNAP TS-212 Question

    I am thinking of purchasing this unit as my first NAS solution (I can get this for about $200), but I have a question. I already have '2' 1TB drives I plan to use. I know that within the next year I will be wanting to upgrade to 3TB drives. Does this NAS give me the ability to perform a drive...
See more
Back
Top
✖