Recent content by Srikanth

Aimesh topology UI doesn't load properly....everytime I have to Ctrl f5 to get the page load properly. Else it shows all plain text without any images

I posted this few weeks back also. Are you able to see PHY rate (backhaul information) on the mesh nodes ? It's always shown as zero in the Aimesh --> Network page.

I have observed that the Aimesh topology page shows my secondary wan status as Cold standby in the network tab whereas the main Network map page shows the secondary wan status as Hot standby (this is correct) Also for the nodes, the backhaul information is not getting populated. All the values...

Upgraded AC86U from Alpha1 to Alpha3 yesterday. It is running lot cooler (atleast by 8 deg) than any recent builds. Ambient temp also dropped a bit here but I don't think that's the reason. Looks like it is really running cooler.

Does the firmware update recognise any new Merlin beta versions when they become available (from GUI or mobile app)

Is it possible to setup usb printer on the node ? I don't see this option in the USB application for Aimesh node

On Alpha build 4 also trendmicro signature update is failing. It was failing on Alpha3 as well. Anyone else facing this issue ? I have AC86U - router and 2 nodes

AC86U - Main router + Node 1 + Node2 Though I selected the preferred backhaul for node 2 as node1, it always connects to the main router with RSSI value as 65 to 68 dBm. Not sure why node1 refuses to stay connected to node1 with RSSI value of 35 to 40dBm. Is the backhaul value of 65 with...

I Gave it enough time to settle. Not using DFS channels. They are not far off from each other. When I checked using wifi analyser I noticed that the node is transmitting signal on the channel related to default region (not the new region I deleted on main router). When I changed it back to the...

No I tried earlier this way and tried now again. Removed the nodes and have reset the nodes (WPS button plus power). Then on the main router changed the region and added the node. Node is not able to connect on 5g as it can't recognise the channel that main router is using.

ASUS, I have 2 AC86U and both of them allow region change to a different country using web UI. When these 2 are connected in mesh, if I change the region on main router and select a 5g channel from that region, node is not able to connect because node still uses the default region. Shouldn't...

RMerlin, I have 2 AC86U and both of them allow region change to a different country using web UI. When these 2 are connected in mesh, if I change the region on main router and select a 5g channel from that region, node is not able to connect because node still uses the default region. Shouldn't...

RMerlin, I have 2 AC86U and both of them allow region change to a different country using web UI. When these 2 are connected in mesh, if I change the region on main router and select a 5g channel from that region, node is not able to connect. Shouldn't the node also use the same region as main...

Signature update is not working. It keeps failing.

When we change the region to a different country on the main router, shouldn't the node also inherit this (if the node router allows region change and not hard coded) ?