Recent content by stewlevine

I have been disabling the wifi adapter so that it is only connected via the ethernet NIC. I thought I was doing all of the right things; I as hoping someone would see something obvious that I was missing.

I assume the Mini CFE Web page would be a page on 192.168.50.1 on the device I am trying to fix. I can't access anything on it in the browser using that address.

I can't get to 192.168.50.1 from a hardwired machine in Chrome, Firefox, or Edge on the same subnet. When I go back to DHCP on that same machine and connect back to the broader network to get onto the internet, that address resolves to one of my working nodes (the one I would eventually like to...

I'm try again. I have verified that this node is HW v1.0 and was manufactured in 2021 so I can use the most recent version firmware on it. I only waited 15-30 seconds before trying to upload. When I have the node in rescue mode and connected from a LAN port on the node to the ethernet port on my...

Yes I did. I have tried setting up the IP address of the Windows computer I am trying to flash it from in both 192.168.1.x (as manual states) and 192.168.50.x (to align with default IP address of the box) and I have tried connecting to both LAN ports (which I believe is the correct way) and the...

Bummer. I was hoping to find a way to revive it (which is why I was looking for a way to use rescue mode, but it does no good if I can get into rescue mode but can't connect to the node once the node is in rescue mode).

That is the exact set of steps I have been following. Unfortunately after completing the steps and power cycling the unit the flashing green never ends up with a stable color but instead repeats the brief white followed by flashing green pattern over and over which is why I am assuming it never...

I have reviewed the instructions. The only reason I am mucking with firmware restoration is because I can't get this node to get into setup mode (i.e., a solid blue LED). On the unit that won't reset, I did once perform setup and was in the process of connecting the other two units as nodes (I...

Maybe I am using the wrong term, but I assume when the device can't initialize (i.e., ever get past flashing green to go to blue and setup or get to any other steady state) there's a real issue. If someone has had this problem and overcome it, I'd much rather get the device working then argue...

Hi. I purchased off eBay a set of XT8 nodes. I went through setup and near the end I walked away and when I came back the node I had setup as the router no longer could connect to a computer (this had occurred while it was connecting to the other nodes to setup AIMesh, so I did not see an error...