Recent content by Striker317

  1. S

    rt-ac68u v4 how to tell it apart

    Hi Re: the rt-ac68u_v4, is there an easy way to tell this apart from other rt-ac68u ? thanks
  2. S

    [ 386.7 alpha Build(s) ] Testing available build(s)

    So I switched the Aura RGB Enable to off. The Aura LED is off. I had to reboot today (turns out it was my internet that was down), but after reboot, the Aura RBG was toggled back to enabled. Disable LED is still set to No.
  3. S

    [ 386.7 alpha Build(s) ] Testing available build(s)

    I see it was enabled on the Aura tab Disable LED is set to No
  4. S

    [ 386.7 alpha Build(s) ] Testing available build(s)

    Confirmed for me too re: Aura RGB reenabling itself after reboot (scheduled or forced). Off prior to reboot, enabled after reboot. GT-AX11000 running GT-AX11000_386.7_alpha1-g8ee6420ea6_cferom_ubi.w
  5. S

    386.5 Alpha1?

    Absolutely not.
  6. S

    Scheduled Reboot - Why?
  7. S

    Scheduled Reboot - Why?

    i hope you are never in a position where you can't reboot. scheduled reboot sounds like it is not for you, but can be a necessity for other people's specific use cases.
  8. S

    AC-3100 with Merlin // How to remove Bell Home Hub 2000 and VLAN35 tagging ?

    Were your killer drivers up to date? I had issues until I updated mine. latest update was 2 weeks ago
  9. S

    Airprint / Bonjour issue

    Is your printer firmware up to date?
  10. S

    [Alpha] 386.2

    Yes, it is still SDA1. It just mounts after dnsmasq runs in 386.2 alpha. Whereas in all other versions, the drive has mounted before dnsmasq is run if I restart dnsmasq after the SDA1 is mounted, it works fine. But not sure that is intended behaviour based on all the past versions.
  11. S

    [Alpha] 386.2

    The problem with this is that the jffs might be reset if I have to start over with a router reset
  12. S

    [Alpha] 386.2

    Any thoughts on this one @RMerlin
  13. S

    AiMesh node does not receive IPv6 from AiMesh router DHCP

    does it happen with the stock firmware? Merlin doesn't change anything with regards to AiMesh, and any fixes would have to come from ASUS.
  14. S

    [Alpha] 386.2

    Hi @RMerlin and others I installed RT-AC86U_386.2_alpha1-gc52b410e89 (both Dirty Flash from 386.1_2 and then from a clean install... subsequent post follows clean install from default) I have a dnsmasq.conf.add file at /jffs/configs Within the .add file, I have a line that says...
  15. S

    Beta Asuswrt-Merlin 386.1 Beta is now available

    RT-AC88U? RT-AX88U?