Recent content by Syl

I had the exact same amount of updates this morning weirdly enough. Seems to be working fine since I updated all of it. Not sure why the update server didn't seem to be getting notified before today.

Finally got this installed after figuring out everything else that was weird, and it's working great! It fixed the "Cannot find NTP server" spam in my log that was causing a 5 minute delay on bootup. I believe that was tied to adguard in some fashion, but with ntpmerlin and chrony I boot up...

Apparently opt/etc/opkg.conf was missing entirely. I have no idea how the hell that could have happend. I was able to do everything else though and now its working! opkg upgrade is actually updating. Wow did it update a lot of files. Thanks a ton!

Apparently my Entware install is quite out of date and I didn't realize it until yesterday. Going through AMTM (which is completely up to date) I get this: Even if I try to change server, it defaults back to / / It goes back to Choosing entware repair reinstall doesn't change anything...

Alright, might not be on your end. Cause I tried to see what was going on with entware and got this. fun. I should figure out what happened there. Update: 100% on my end. Still not sure why i can't reach entware, but i'll figure it out.

Attempted to install ntpmerlin via AMTM on my AXE-16000 or Which caused nonstop (or the same message with chrony) So I just uninstalled it for now. Or tried too, but got - Any ideas?

GT-AXE16000 here, dirty upgrade from 102.5 and while it took a little longer to install compared to normal, looks like everything is working perfectly fine since! Thanks for everything you do Merlin!

Thank you! This worked and it looks like everything is going smooth so far.

Alright, I messed up and I'm not so good at the terminal thing. I started to install YazDHCP and long story short, things got aborted during the installation and if I try to launch it via amtm I get this. Is there any terminal command to remove YazDHCP so I can uninstall it and attempt to...

I don't use guest networks. I have a precarious balance of nearly 100 IOT devices across both 2.4 and 5ghz along with two nodes and I don't want to possibly break that. I'm starting to get some odd messages in the system log though, Most of it appears to be related to amtm but this is a new...

Dirty upgrade on my AXE-16000 overnight and it seems like there's no complications in the morning! Even with my (no longer supported) AI-Mesh extenders being on different firmware.

Also wanted to mention that I have had zero problems since 1.9.3 on my AXE16000. Everything is running as smoothly as can be after multiple days.

I actually have never used the Guest Network Pro, so I don't know if i'd be too much help there. Because my main router and my two nodes all have different WiFi capabilities I've just been letting the router handle it on default with roaming, which is stable for my network of 60+ IOT devices...

Hello, new to this forum but i've been using AMTM Adguard Home for multiple years now. It's only recently that i've been getting issues so i've been following this thread. I was getting a peculiar situation where Adguard Home would run and I could access the webui, but I couldn't access AGH...