Menu
What's new
By:
Filters Better Search

Recent content by tenwx

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. tenwx

    IPv6 'upnp' pin holes

    Can merlin add ipv6 support for miniupnpd now? It's been 7 years since this post. More and more p2p software already supports ipv6 pin holes. For security reason, we have to open the ipv6 firewall in merlin. But it'll cause the restriction of ipv6 inbound traffic. So it is very necessary for...
  2. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    At present, my bypass method is to manually add the "service start_upnp" command to the /jffs/scripts/nat-start script.
  3. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    My secondary WAN connection is Ethernet. I used the script you provided, but after restarting, there are still no relevant logs in syslog.
  4. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    Yes I confirmed.
  5. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    I didn't find any keywords about upnp in syslog. I also tried turning off the dual wan function, and miniupnpd works fine. When I use the "service restart_upnp" command, I finally found that the miniupnpd process is up. It looks like the router will automatically skip upnp startup when it booted.
  6. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    Yes, I did a factory reset after upgrading the firmware, I reconfigured everything.
  7. tenwx

    Asus RT-AC68U merlin 386.5 can't start miniupnpd when enabled dual wan in balance mode

    I'm using Asus RT-AC68U for many years. Recently I upgraded the merlin firmware from 380.68 to 386.5. Everything seems perfect except the upnp problem which is confusing me. I turned on dual wan with balanced mode as before, also I turned on the upnp service in the wan config page. But I found...
See more
Top