What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by thedroid

  1. T

    Help with Layer 3 Switch Setup

    Thanks for the help so far, unfortunately I have to put this down for a couple of days, will review and revisit then
  2. T

    Help with Layer 3 Switch Setup

    There are three options Enable NAT (ticked) Enable Fullcone NAT (unticked) Enable SIP (unticked)
  3. T

    Help with Layer 3 Switch Setup

    Thanks both for all the help. As far as I can see, there are two settings with which I can adjust firewall info. One the LAN settings and one on the WAN settings. Modem_Wan_Settings.jpg Modem_Lan_Settings.jpg Currently I have both disabled, but still no luck. I'll dig through the UI...
  4. T

    Help with Layer 3 Switch Setup

    Pretty sure that the routing in the modem is correct. Please see the attached link. Modem Routing table I don't see anywhere to get a internal NAT network list.
  5. T

    Help with Layer 3 Switch Setup

    @abailey, thanks for helping out with this. Doing a ping or a trace route to www.google.com from within the ASUS works fine. Doing the same from a device on the .10.x or .20.x VLAN does not. This as you stated, only makes it to the 192.168.1.1 interface before it times out. Any suggestions as...
  6. T

    Help with Layer 3 Switch Setup

    I am trying to apply info in the tutorial and examples from http://www.smallnetbuilder.com/lanwan/lanwan-howto/32098-how-to-use-a-layer-3-switch-in-a-small-network My hardware is different utilizing a SmartRG 500N as the gateway and an ASUS N-16 running tomato USB as a layer 3 switch. The...
  7. T

    Asuswrt-Merlin and Huawei E5375 LTE

    Has anyone had success with configuring an E5375 LTE with Merlin 3.0.0.4.374.39? This model is not listed in the USB adapter drop down, but it is detected by the router (RT-66). I have however yet to establish an internet connection through it.
See more
Back
Top
✖