Recent content by TNR27

same hear except 2.4 is labeled as "undefined"

Can someone explain how this done? Thanks

Correction!!! RMerlin is correct again I just performed router reboot and I am NO longer able to refresh the client list.:confused: but what I did notice is the little icon beside the the windows home server 2011 client has been a man in suit (other device) since reboot it is a pc with a...

I am pretty confident that its not intermittent. I have spent many hours trouble shooting this. I can guarantee you that this the only RMerlin f/w that allowed a "client status" refresh on my setup. All asus f/w up to 3.0.0.4.374.4422 would also allow a "client status refresh" but any version...

WHS 2011 Client List Loaded 374.40_beta 1 this morning seems to running fine. I also want to report that the issue with pc running Windows Home Server 2011 causing the "Client Status" To fail after hitting refresh is fixed. Here is a link to issue...

Ok I have just booted the WHS2011 in safe mode with networking. I am now able to refresh client list!:rolleyes: Any thoughts?

I had a 66u prior to my 68u running Merlin firmware and didn't have this issue. I was running .374.35-2 up to middle of last November then purchased 68u. As soon as I set up the 68u it hasn't worked. I have tried installing a network card and disabling onboard LAN. No go.

Ok did some digging using Google, got it setup but still no go.:mad:

Unfortunately I don't think I could set that up without direction. Not very tech savvy.

Is there a work around?

3.0.0.4_374_4422 Hello RMerlin, I know I keep bringing this issue up concerning my 68u, but I am still trying to resolve. I am still having the issue with my "Client Status" list not being able to refresh. It is my pc running WHS 2011 that hangs it up. If I disconnect the client or...

I have the what seems to be the same issue. I also had a 66u prior to my 68u and used merlin firmware the 66u and didn't notice this issue. But I only had 66u a couple of weeks before the 68u went on special so returned the 66 and purchased the 68. see link in this topic...

First of all this new release .39 has been working flawlessly. Great work! But unfortunately I am still not able to fix my client status list issue that is caused by my pc running windows home server 2011. see this post...

This is what I had to do to figure our out the client that was causing the problem. - Unplug client "a" then reboot router (this is a must because in my case once the router adds the "bad" client to the list it will never refresh until a reboot) - wait for the client list to fully...

Have you tried disconnecting each hardwired client one by one to determine which one causes it. Maybe it has to do with the network adapter/controller of that particular client. Maybe between us we can see similarities in the chip and or settings.