Recent content by Toni

Thanks for this new release Voxel! I see a new message repeating every few seconds on my log since the update to 1.4.41: May 27 21:48:32 R9000 sysinit: killall: nslookup: no process killed May 27 21:48:32 R9000 sysinit: ***(pot.c,main,379): command name is wrong! May 27 21:48:41 R9000 sysinit...

If you’re using DFS channels, probably you router is detecting a RADAR signal on the channels it’s running and it shutdown this channels. Probably this is the reason. Before start transmission on this channels the router should wait listening ten minutes on them. Sent from my iPad using Tapatalk

Upgraded to 1.0.4.39.1HF from your previous version. I became aware of the problem after this upgrade and tried different things like going to the official firmware and tested some previous versions of your firmware. Also tried to downgrade the ES8 because Ubiquiti released a new switch...

In first place thanks for your good work, your last toolchain update amazes me. Lately I changed a lot of versions of your firmware trying to fix a problem I detected after upgrading to 1.0.4.39.1, not sure when appeared. Maybe my setup is uncommon with the following gear: Netgear R9000...