Recent content by tonymet

this is a great tip i'll see if these configuration profiles provide a way to rotate SSIDs e.g. "if SSID-A then use it, else use SSID-B". great tip!

Again, let's just assume we've already decided on that. The point of this topic is to discuss how we would go about rotating the shared secret. Do you have any helpful thoughts on that?

In reading this it goes against most of the conventional wisdom of secret management. Regardless, let's just assume the goal is to rotate the shared secret (the point of the topic). Any suggestions?

Just to bring us back on topic. What are the best practices for shared secret rotation. that's the point--how to reduce admin overhead.

Why is this shared secret exceptional ?

Let's assume you like to rotate your WPA2 shared secret (SSID passphrase) once a year. How do you do it without downtime and with minimal fuss? Is it possible to do it without changing SSID? Here's how I do it: Start with existing SSID `wireless-net` Add new virtual SSID `wireless-net-A`...

@drinkingbird would false attribution stats (e.g. wrong client IP / Mac) in traffic analyzer statistics count as a bug? this one caused some trash when I thought my network was hacked.

I also have been getting really wild statistics . e.g. a Smart Plug transferring 45GB / day and my Brother Printer 8 GB / day

I've been experiencing this with RT-AC5300 with both factory latest & Merlin stable firmware (currently 386.7_2) . ``` Deauth_ind xxx, status: 0, reason: Deauthenticated because sending station is leaving (or has left) IBSS or ESS (3), rssi:-69 May 4 22:05:21 WAN Connection: WAN was restored...

Yours looks different than mine

Can you check the console-based routing table there? it should show up

@csm10495 see comment above that should work for you.

Same issue with RT-AC5300 . It's not accepting the route configuration from the cable modem SOLUTION: Add a static route Network / Host IP = 192.168.100.1 Netmask = 255.255.255.255 Gateway = 0.0.0.0 (shows as * in system routing table once saved) Metric = 1 (default) Interface = WAN Add...

this is off topic

Only 1 AP is active for this solution.