Recent content by ttgapers

Yep it does!

Updated and all smooth. Had to exit amtm and re-enter wf for Option 1 to show the current version. It was indicating an update available while the main menu showed current status correctly.

Thanks for this. I have been manually restarting for a little while now lol :)

I am experiencing the same flapping issue. No rush @Ranger802004 - but any idea(s) on when a new release is slated to deal with that specific issue? Cheers and thanks as usual :)

Works like a charm on my AC86U from inception. Just minor bugs that @Ranger802004 took care of relatively quickly. Note I use mine configured in HA mode active/passive, not load balancing active/active.

Thanks @Ranger802004 - haven't been able to update/test anything due to LIFE, but looking forward to the new beta/release soon. Cheers

Yep @Kingp1n -- hope all is well. in the readme: https://raw.githubusercontent.com/Ranger802004/asusmerlin/main/wan-failover-readme.txt - WAN0_QOS_OVERHEAD: This will define WAN0 Packet Overhead when QoS is Enabled. Default: 0 Bytes - WAN1_QOS_OVERHEAD: This will define WAN1 Packet...

Like this? https://www.snbforums.com/threads/dual-wan-failover-script.78978/

Ok. Checked all my other custom scripts. Removed Cake, did some Flex cleanup and now QoS disabled. Will allow to sit before reinstalling Cake and setting to disabled sometime tomorrow.

@dave14305 - If I manually switch off QoS (toggle or via nvram set to 0), in less than one hour it is back on again. So trying to figure out "what" might be causing it. I know weird. Will have to spend some time to track it down. Just threw this out here for you primarily to comment on. Have you...

Cake-QoS adds this to firewall-start sh /jffs/addons/cake-qos/cake-qos startup # CakeQOS-Merlin The code does this check first to see if QoS is disabled or Cake is not selected as QoS type. if [ "$(nvram get qos_enable)" != "1" ] || [ "$(nvram get qos_type)" != "9" ]; then...

@Ranger802004 Just was reviewing your check for QoS and reset for QoS and I think we need to sync. For the CakeQoS script we check for QoS settings via Is it possible for wan-failover to check for Cake QoS option as well and disable/enable as required? Think your settings are here And I...

k i will have a look at cake...

@Ranger802004 looks like the cron for "wan-failover run" job appears to re-enabling the QoS on my faster WAN0 connection every hour (not respecting the conf file). I will do some digging to see if it's one of the other scripts but doubt it at this point. Cheers!

Looks much better in regard to QoS disable/enable based on settings in conf. Will monitor.