Recent content by tuzok

It has been quite a while, but still could not make it work. I have a RT-AC68U as parent Aimesh router and a DSL-AC68U as a mesh node. It works fine with wireless connection (have not done many tests but the connection between the two routers are good). My intention is to connect them via...

Perfect! Thank you.

In case of DSL there is no WAN port and the DSL connector is not RJ45, so one of the LAN ports must be used, I think. Unfortunately forcing the connection priority does not help :(

Which LAN port should be used on the DSL-AC68U when setup as aimesh node? So far tried LAN1 and LAN4, none works, always stays as wireless. I have uploaded the latest firmware and did a factory reset.

In case I want to use the DSL-AC68U as a node with Ethernet backhaul, which port shall I use? Would it work at all? Is there a way to configure e.g. LAN port 1 to act as WAN port? Thank you!!!

Hello! In case the DSL-AC68U is acting as a node in AiMesh, can I use Ethernet backhaul? If yes which port? Thanks in advance!!!