Recent content by Vexed

I've been using a GX-424CC based opnsense firewall, 2x Dynalink DL-WRX36s (OpenWRT NSS AP mode) and a 68U (Merlin AP mode) for my two flat networks. 10 years was a pretty good run but it reinforced my worldview that Broadcom products should be avoided. Terrible firmware support (see...

Set the Wireguard listen port to 53. Clients send DNS queries via UDP on port 53 so if you share the same port numbers you get past low-skill filtering solutions.

A lot of public hotspots block most if not all UDP traffic which is what Wireguard uses.

@gjf A bit of a late response, I forgot to follow up but I'm here. If your router's maxp*ga* settings are already maxed out to 120, your router is in manufacturing mode, and you set all the non-zero mcsbw* values to 0x00000000 by writing them to the cfe... The router dumps so much dirty RF...

I'm just leaving this here in case I actually found anything of note. If not just disregard. My setup is an RT-AC68U with Merlin 384.14_2. Scenario 1. I was pentesting with mdk4's packet fuzzer using assorted flags. After a few minutes of this I noticed packets to/from WAN would randomly drop...

1:mcsbw805glpo=0x88653320 1:mcsbw805ghpo=0x88653320 0:mcsbw402gpo=0x88653320 0:mcsbw202gpo=0x88653320 1:mcsbw405glpo=0x88653320 1:mcsbw405ghpo=0x88653320 1:mcsbw205gmpo=0x88653320 1:mcsbw205glpo=0x88653320 1:mcsbw805gmpo=0x88653320 1:mcsbw205ghpo=0x88653320 1:mcsbw405gmpo=0x88653320...