Recent content by Weblee2407

After updating and getting everything setup beside the above issue - Skynet is logging blocks to "ns1.anycastdns.cz" . Is there a component of the new FW that is attempting to connect to this DNS, and if not any advice/info on what else might be causing it?

Was there any: 1 - formal resolution to the missing NTP fields issue -or- 2 - Detailed HTTP editing directions for manually updating the HTML

Added the CN name check in the GUI to match profile; TLS regeneration got set in the GUI to 0; set to -1 and working now

Multi reset, from scratch minimal config - issue persists, but now I do not get any syslog postings. Tried with both cable modem and a fiber ONT. anyone with any ideal

I am trying to set up a NORDVPN client profile, but the router will not save/keep the uploaded profile. This is a from scratch installation. If I upload the vpn profile, it will confirm the upload and then erase it. Logs: Dec 21 09:36:05 terminator ovpn-client1[16091]: write UDPv4 []...

Performed a Fresh install and now the router is incrementing the maximum erase counter every 3 hours. I wrote a script to monitor bad block remaps on another router I had problems getting Asus to RMA and script became part of my custom scripts collection so the max erase counter data is...

Well after testing using a minimal config I found the cable modem NEVER gets an IP as the standby in failover mode. It never went into and maintained hot-standby status. If I set the dual WAN to load balance and then install the WF script, everything works as expected. I believe the issue is...

Can you tell me what types of connections you are using please?

GT-Ax6000 running 3006.102.4 Primary is 1 GB fiber connection with cable modem based (Spectrum) 1 Gb for secondary. Add Ons: AMTM 6.0.2 Diversion 5.4.5, SkyNet 7.6.4, Scribe 3.2.1, uiScribe 1.4.5, Unbound 3.25, BackupMon 1.8.22 Sometimes options of the script, specifically manual failover, seem...

1GB cable modem connection

I use the GUI to fail over. The script does not have any impact

Is there a tutorial for this script? I need a HOW-TO because my status says WAN failover disabled but cant find a way to enable it. I dont believe the secondary 2.5GB is without IP until it is enabled. Are problems being reported on GT-AX6000 using 3006.102.4? Should both be active with an...

After some hit and misses, I pushed the easy button and rolled back to the last revision I knew supported the iPhone tether. After all, I do have backupmon ;) I'm shocked that after the storm early yesterday afternoon, I just got a text that the company has started to route around the power...

No because I had no idea of the inputs. Let me search the forum and see whats being used.