Recent content by weebler

I'm not sure, but I will suggest to look specifically at item #22 in the support article - which is holding down the reset while powering back on. There is another NG article floating around on the web that is almost the same except that it omits holding down the reset while powering on, which...

I was able to reflash the router using Windows TFTP to 192.168.1.1 on latest stock firmware, then updated to your latest firmware. All seems good now. Was scared, thought I bricked it somehow.

I forgot to mention that my isp modem has a default 192.168.1.254 ip address so the 192.168.1.1 shouldn't conflict, I just can't get into it on the rbr

I tried the reset a few times. I think the first may have been while still connected to isp modem. When rbr disconnected from modem and pc connected to rbr I can't access 192.168.1.1 at all. When I reset the rbr it flashes the orange power light correctly and then when I release the paper clip...

Tried everything you suggested. Even after the reset it still just pulses white. Can't even get in with plugging pc directly into RBR, and plugging RBR back into isp modem or even directly in the fibre modem neither recognize with an ip address. Nothing on 192.168.1.1, when set up as AP on my...

Hello, I upgraded to your latest firmware from 2.5.0.42 and now I can't get into the router settings. In fact, the orbi doesn't seem to be recognized at all. I was using it as an AP. Power cycle and reset with a paper clip does nothing, it just pulses white. Any suggestions? Is it pooched?

I guess maybe I am. Are we getting closer to funding?

Donated. Small, but I think enough people are on board we should get this pretty quick.

Netgear recently released a new firmware and is still a mess for some. A loaner unit happening so we can get some decent firmware?

I am using your firmware for the R7800, so would be very interested in firmware for the Orbi. Any time frame of when/if this will happen?