Recent content by westmc

So with DoT enabled, the only way that it could be tampered with is if cloudflare itself got hacked since DoT would prevent a man-in-the-middle attack, right?

Does that mean that I don't need to enable DNSSEC if cloudflare is already doing it?

I loosely followed the beta thread so I know that people had issues with cloudflare + DNSSEC but I am confused. I just upgraded tonight, enabled DoT (to cloudflare, which I was already using) without issue. When I go to the cloudflare test page with DNSSEC disabled, it tells me that I am...

I did a slightly abbreviated version of your suggestion. I work in the computer field and as often as I jokingly ask "did you reboot three times?" when there is an issue, I can't bring myself to do it myself. I factory reset, formatted jffs, re-flashed, factory reset, and have been slowly...

I just set it back to 11/48 and within about 20 minutes the 2.4 channel switched back to 6.

WIFI scanning apps confirm the channels shown under the wireless log (which does not match what it is set to).

It shows... wl_chanspec=11 size: 52908 bytes (12628 left) wl0_chanspec=11 wl1_chanspec=48/80 Which is what my settings display, but is not what it is actually broadcasting on.

I see you have the 86U and 68U, so it is either the 68P or my router specifically. Anybody else with the 68P?

Are you checking the wireless log screen to see the actual channel being used or just looking at your settings screen?

Yes, but it isn't a question of hacking because my configured settings still show what I set it to. As you can see in the screenshots, I have it set to 11/48 but it is actually using 6/36. If I go back to the settings screen and hit save, it won't actually do anything. I would have to change...

No, whenever I have done factory resets, I always put in the settings manually. I'm just curious if this is more widespread and nobody notices. I find it hard to believe that I am the only one with this problem. I know the 68P is a lot less common than the 68U, so I guess it is possible that...

I've posted about this a few times but I've never received an answer. Figured I would try again. My RT-AC68P (currently running 384.10) will randomly switch channels on both 2.4 and 5.0 even though I have manually set them. This has been happening for years, through multiple versions of...

I just switched from a 4tb WD Elements external HDD hooked up to my RT-AC68P to a Synology DS218+ with 2 10tb WD White drives. The interesting thing is that I used Crystal Disk Mark running against a mapped network drive and both showed similar speeds yet my weekly backup went from taking...

Running RT-AC68P with 384.7 and it isn't there. I have a "USB Setting" section but the only option is "Enable HDD Hibernation"

Where is this new "USB Mode" I've searched through every screen but I can't find it (RT-AC68P).