Recent content by WJJP

Well, I believe the issue is with smart connect feature. So disabling wireless bands on one router, will not solve the issue I think. Smart connect helps in a mesh network to steer your devices to the router with the best connection, but also to the correct band on that router. So even if you...

Hi, I think the buffer errors have something to do with the smart connect. This helps devices with switching between routers. When disabling smart connect these errors will disappear, but the downside is that your devices are no longer pointed to the closest router /best wifi signal available...

Removing a node does not change any settings on your device per se I believe. Do you have smart connect enabled under wireless settings? Can you maybe post extract of your General log which shows a short time before the ring buffers start? Can you tell us what traffic is going on when the...

In AiMesh mode, the general log was filled up with connect and disconnect messages for stations all day long. While in manual mode these messages are almost inexistant. Could it be that the continuous leaving and joining from stations, together with continuous streaming on the network crashes...

Hi, I stopped using Aimesh and configured router manually. Never had the ring buffer error again. If you want some starting point on how to do this, I have posted my manual settings on this forum a few weeks ago.

When using repeater mode, make sure the repeater use same values as main RTR for similar settings. I noticed that this wasn't always the case. Connect through SSH to the repeater. Working with different ssid for different bands ensures you can select the highest speed band. To see link rate per...

Hi, hard too see what's going on without more information. Can you provide an overview of both setups? (e.g. is it internet-ax92-ax92 vs. internet-linksys-ac86u or...) How far are the second units removed from the bedroom? Can you put a number on the actual speed for both setups? (e.g. from...

https://www.snbforums.com/threads/rt-ax92u-manual-settings-for-stable-wireless-connection.62417/ this is a post from few weeks ago where I documented my settings.

Hi, I had same issue that wiring was no option inside an old brick building and I took the AX92 duo pack. They are connected using manual setup, because the AiMesh was totally unstable for me. My main media machine is connected with a cable to the node, and uses the wireless backhaul to the...

Do you mean it only works on the chosen band on wifi tab?

Hi, are you using the AiMesh feature with smart connect rules? If so I had similar issues, and configuring one of the Ax92 as router and the other one as repeater works a lot more stable. (I posted a long post last week, with settings you could use) As for 160MHz band=> never had any luck with...

Hi, on mine port forwarding is working. Ports that are forwarded are shown as open when I test them.

Just make sure you connect the RPT to the SSID of your RTR 5GHz-2 band and for easy access afterwards you set a manual ip address for the RPT. That way it's easier to ssh in to the RPT to enable ax mode for 5Ghz2 band. The LAN works for me the same behind the RPT as with AiMesh => my main...

As explained in another post of mine here , I went to manual settings. The whole setup is there . My idea with this setup was indeed to have some kind of manual mesh with the 5Ghz-2 reserved for backhaul traffic. Up to you if you try the manual settings, but for me they were an improvement...

Did you compare the wireless log from both situations? If not, maybe an idea to check this one