Recent content by xleanone

Resolution without solution I went back in a few minutes ago and disabled TELNET (which I had enabled for the NVRAM Save/Restore script). The log entries stopped and have not re-appeared so I conclude that something in the TELNET enablement caused the errant messages that resulted in the log...

Yesterday I installed Merlin's 3.0.0.4_376_49_5 firmware. I run the router in AP mode off my Verizon box to get better wireless performance. Everything seemed to operate just fine. This morning I went ahead and cleared NVRAM, restored factory defaults and reset all my settings (I used the NVRAM...

Tim: Thanks. There are, in fact, 2 adapters showing in both Control Panel - Network and Sharing and in Device Manger, even after a de-install, clean up and re-install. The tip-off was that, in Device Manger, the physical bus locations were different for the two adapters. This Dell PC has...

Reply to QX 1. Bandwidth on 5GHz band left at default 20/40/80. Does it need to be set to 80 to allow/force 802.11ac connection? 2. Have not used IPERF (I'd never heard of it until now). From my quick reading it's a network performance measurement tool used between 2 units, a client and a...

Let me begin by saying that my WiFi knowledge is not great and my general networking knowledge is ancient history (Think Cat 2 cabling and Vine networks). I picked up an RT-AC66U and the PCE-66U to go with it. The router is set up in Access Point mode, hard wired to my Verizon supplied...

PCE-AC66U Utility Window Issue I had the same problem. Check the Display Size setting (Win 7 Control Panel - Display - Display Size). If it's set at anything above 100% (the default) the GUI window is messed up. Regards. Tom