Recent content by zero65

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. Z

    Centurylink 1Gbps WAN Speed 1/2 what it should be

    So what I did was put a managed switch between my ont with vlan id 201 and the my wan port rt-ac1900p and turned off IPTV ...adn I have my download/upload speed....940 up and down consistently...Thank you all
  2. Z

    firewall-start question for rt-ac1900p/ac-68u

    I just switched from Cable to Fiber and the below firewall rule stopped working: iptables -I FORWARD -p ALL -i br0 -o eth0 -m iprange --src-range 192.168.2.5-192.168.2.109 -j DROP I am in 380.68_4.....I am guessing interface is wrong now.....but I have tried ppp0 and that did not work...
  3. Z

    Centurylink 1Gbps WAN Speed 1/2 what it should be

    I have a rt-ac1900p running merlin 380.68.4 and my download speeds never exceed 500Mbps where as my upload speeds usually get to around 900Mbps . In the switch control I can see the following NAT Acceleration CTF (Cut Through Forwarding) is enabled. So I have CTF enabled...I have qos...
  4. Z

    firewall-start question/help

    Perfect that was it! Thank you Merlin!
  5. Z

    firewall-start question/help

    1st of all want to say great firmware! I am using 3.0.0.4.374.37_1-sdk5-oldusb and all is good. I am trying to lock down my network a bit more but can't figure what I am doing wrong. created firewall-start and it runs... with following: #!/bin/sh ############# # Firewalling...
Top