Menu
What's new
By:
Filters Better Search

acl

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. GikaH

    (solved) Block port 389 in ACL

    Hi! I've been attacked (DDOS etc) I'm looking for possibility to block port 389 (used by LDAP). After researching this a little in web I found that there is only a guide for Cisco routers etc. So I checked whole RT-AC87U GUI but found nothing. After that I just added a firewall rule to...
  2. A

    RT-AC68U Access Control Lists ACL

    So I have installed acl via entware (opkg install acl) and have access to getfacl and setfacl however any attempt to use setfacl on USB connected drives results in "Operation not supported". setfacl on a test file in /tmp works fine. Firmware is 384.4 stable. USB drives are formatted as ext3. I...
  3. M

    Cisco RV320 ACLs not working

    Hi all, I was hoping to get some help configuring a Cisco RV320 router. The RV320 is at a remote location, I want to configure a port forward for remote desktop from my public static IP address through the RV320 to a server on the RV320's internal lan. I have setup port forwarding on the RV320...
    • mangyDOG
    • Thread
    • acl cisco firewall rv320
    • Replies: 3
    • Forum: Routers
  4. K

    Optimizing access control lists on a Cisco SG500X-48 Small Business switch

    I am trying to optimize the access control list rules on a Cisco SG500X-48 Small Business switch (on Layer 3). The general aim is to regulate the traffic between two VLANs (e.g., 10 and 30) in such a way that VLAN 30 has access to VLAN 10, but only for specific protocols, while VLAN 10 has no...
Top