subnet

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. P

    OpenVPN with Networked Drive

    Hello all, I am fairly new to OpenVPN and have been using it fine for the past year to access my local network when away. My initial use for the VPN or 'Traffic Tunnel' as others may call it, was to be able to stream movies off my HDD connected to my RT-AC3100 running Merlin 384.19. I use an...
  2. U

    IPv6 Native vs Passthrough (2-Router LAN)

    Topology Two ASUS routers: 1st plugged into a modem (w/ WAN aggregation) 2nd plugged into the first router both are in router mode and not set up as an AP One of the reason I opted for this setup is that I liked the idea of having a firewall on the client-router in order to apply some more...
  3. M

    Configuring OpenVPN Server to Permit Access to Multiple Sublans

    I have an Asus RT-AC68U router running Asuswrt Merlin connected to a Cable Router at a remote location. I am trying to configure an OpenVPN Server on this router that will let me setup a client VPN connection from another RT-AC68U at a different location that will provide access to the networks...
  4. C

    Network design help with 2sites, VPN and VLAN - Unifi

    Hi all I'm going to make my 2 site network design a big more secure/segregated and need some advice. See below for the basic idea. But I am no network expert at all, so maybe (most likely) will simply not work. What I want: the 3 'profesional' networks (2 sites and VPN) need to be...
  5. T

    WAN throughput slower without NAT

    I recently added an RT-AC68U to my home network to create a subnetwork. However, after disabling NAT my WAN throughput dropped to 400Mbit (CPU1 100% and CPU2 60% load) from the recent 930Mbit (CPU1+2 at 100% load). Is this expected behaviour? Shouldn't disabling features increase speed rather...
  6. A

    OpenVPN Subnet visibility at LAN subnet

    Hi, I have my LAN network on 192.168.2.0/24, and an OpenVPN server at 192.168.3.0/24 subnet. From the VPN subnet I can access without problems my NAS and other servers on the LAN network by IP, but I cannot connect to my PS4 over remote play (it has static IP) through the VPN. I think it's...
  7. R

    Multi-Router - Multi-LAN network help please!

    Hello everybody, I have a relatively complex network building in progress, and I would like some help from the experienced networking people here! It's a three story building. I have two VDSL2 connections coming in with their according modem/routers, a Cisco dual wan load balancing router set...
  8. B

    Not connecting to RDP via VPN

    I have a PC I can RDP in to when on the home network but can't when on the OpenVPN connection. It's on the same /24 subnet and I can access the router webpage (via VPN) but no connection to the PC via RDP except when on the network directly (not via VPN). It started when I had to re-setup my...
  9. T

    Traffic Monitoring of multiple different subnets! (VlAN/DHCP)

    Device: RT-N66U Firmware: 380.69 Hello everyone, i attached a tp-link access point to my router and created vlans for several SSIDs. In addition i would like to use the traffic monitoring of the router as i did before. I noticed that only the devices directly attached to the routers are being...
  10. B

    change subnet mask in network - change everywhere?

    Hi, I changed my subnet mask on my gateway to 255.255.252.0. I have a couple of managed switches as well devices with static IPs. Do I have to change the subnet mask to 252 in every switch and every device? Here is where I am stuck right now (all Asus on Merlin 384.9): I have change my WAN...
  11. L

    setting up subnet for neighbor

    I'm sharing an Internet connection over a wireless link between two houses on the same property. I've set up a secondary router (Edge) as a local client, plugged into my local (ASUS) wifi router, then the Edge router uses DHCP to provide IP addresses to their clients. This does seem to work...
  12. I

    Two Asus Routers Chained Together (LAN -> WAN) [one dedicated VPN router]

    Here is my setup Router 1: 192.168.1.1 subnet: 255.255.255.0 FW version: 3.0.0.4.380_7266 Router 2: IP leased from Router 1: 192.168.1.11. Own IP is 10.0.0.1 subnet: 255.0.0.0 Asuswrt-merlin: FW version:380.65 Computer A: plugged into Router 1 with IP 192.168.1.189 Computer B: plugged into...
  13. D

    Mikrotik DHCP Routing

    Didn’t really know what to call this.. So I am trying to achieve the following I have an ubiquiti wireless AP and a Mikrotik hapac2. I want to have two wireless networks one of which will give internet access over a vpn (route 192.168.0.3) and the other straight to wan (route 192.168.0.3). Now...
  14. LighthammerX

    Setting up an ASUS RT-N66U running Merlin on an existing network

    Greetings, I did some research on this forum and other sites on this topic, so if I am asking information that does exist and I missed, I apologize ahead of time; though this is a fairly esoteric situation. I've been running a server setup running FTP, Emby, HTTP and a few other services over...
  15. T

    Subnet of ISP modem/router and merlin router AC68u must be the same

    Hi, I bought a new asus router, the ac68u rev E1. My old asus was N66U with tomato shibby firmware. I need to keep the router/modem of my ISP, this is a must for me (I have to keep a wireless/router"backup"-connection!) I want to configure my asus router (merlin firmware, because tomato...
  16. T

    Asus RT-N66U - separate groups of devices to prevent them from seeing each other

    Hi, I have a Asus RT-N66U and would like to separate some devices from a group of other devices. I will prevent the devices in one group to access the devices in the other group. I guess this has something with subnet mask to do? Am I right? In the Setting menu under LAN there is a LAN IP...
  17. N

    Asus openvpn same subnet local/remote workaround?

    I am wondering if someone can tell me how to setup a subnet alias/masq/translation/forwarding/mapped (not sure of the correct term) on the asus firewall. Here is the scenario asus stock firmware, openvpn server, workplace subnet is stuck at 192.168.1.x vpn/rdc works great for remote workers...
  18. A

    How to connect an ethernet device to wireless network on the same subnet of the router?

    Hi I have a wireless router on the ground floor which has DHCP server running. Now on the next floor, I have a device which has an ethernet port and I want to connect this device to the earlier said wireless network(Have considerable wifi strength here), but want it to be in the same subnet of...
  19. C

    How to best restrict what resources a VPN client can access (noob)?

    Hello all I'm a networking novice looking to setup a VPN that allows me to securely access my local NAS over the WAN. I already have this running using PPTP. The router acts as the VPN server. As it is now, this provides the VPN client (Windows & Linux laptops) unrestricted access to my entire...
  20. S

    [I think] I need help with static routing?

    Hello, I have three routers: (Router # 1) AT&T Uverse RG (default settings, set by AT&T) SSID = "Uverse" DHCP enabled Basically, I only use this as the internet gateway for my other two routers. LAN IP = 192.168.1.254 (Router # 2) Asus RT-AC56R (Merlin firmware) SSID = "VPN" DHCP enabled WAN...
Top