Command to "reapply" IPv6 configuration

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.

jeden

Regular Contributor
I am using a 6in4 tunnel to get IPv6 connectivity. Every time the router boots some of my devices lose connectivity constantly until I go to the web panel and hit "Apply" in the IPv6 section. Once this is done I have no problems until the router reboots.

Is there a way to do this automatically, say, one minute after the router boots? I can figure out the part where the command is launched, but I don't know which command to launch.
 
Last edited:

dave14305

Part of the Furniture
The IPv6 page triggers restart_net when you press apply. The equivalent command line is service restart_net but that seems like a nuclear option right after a reboot.
 

jeden

Regular Contributor
Taking into account the inordinate amount of time wifi takes to start after a boot, it won't affect any device. So I'll try that. Thanks.
 

Similar threads

Latest threads

Sign Up For SNBForums Daily Digest

Get an update of what's new every day delivered to your mailbox. Sign up here!
Top