I have two USB drives. Both have been successfuly mounted tom my router up to a few days ago when neither of them was being recognised.
I have upgraded to the latest RMerlin firmware and hard reset and re set up my router from scratch.
The drives are now being seen by the router with the Lacie USB drive functioning correctly formatted as a FAT drive.
The other is a generic sata drive in a usb cradle. It works fine connected to my laptop running linux fedora 17. I have one partition on it formatted as ext3.
I can read and write to it from the linux laptop but when I plug it into the router it shows up as unmounted.
I guess I could telnet in and mount it but is there any way I can get it to mount automaticaly?
I have upgraded to the latest RMerlin firmware and hard reset and re set up my router from scratch.
The drives are now being seen by the router with the Lacie USB drive functioning correctly formatted as a FAT drive.
The other is a generic sata drive in a usb cradle. It works fine connected to my laptop running linux fedora 17. I have one partition on it formatted as ext3.
I can read and write to it from the linux laptop but when I plug it into the router it shows up as unmounted.
I guess I could telnet in and mount it but is there any way I can get it to mount automaticaly?