Help needed in resetting EA-N66 Dual-Band 450Mbps

[trumpeter96]

I have a EA-N66 and i need help getting it to factory default. I tried turning off the power, hold onto the reset button and then power it on while holding onto the button for about 15second. I also tired it with the WPS button but both doesn't seem to work. I use the discovery tool and it cant find the AP to configure it. I have the connection of my PC set to DHCP and the result i get is, IPv4 Address: 169.254.205.219 , Subnet Mask: 255.255.0.0 . I am unable to get a default gateway.

 

[matsayz]

Leave it powered on and then press & hold the reset button for 15+seconds or until the lights start flashing

Here's the manual fyi, http://dlcdnet.asus.com/pub/ASUS/wireless/EA-N66/E8111_EA_N66_QSG.pdf

 

[trumpeter96]

Tired that, still unable to access the GUI configuration page.

 

[L&LD]

Specify the PC's connection as 192.168.1.100 instead of using DHCP.

 

[trumpeter96]

Thanks for the help! But it still does not work
So i set my IP as 192.168.1.100/24 right? After doing that i still can't connect to the AP. I try with and without the gateway of 192.168.1.1 and both doesn't work. I will get a Unidentified network.
By the way, this problem occur because the WPS button was pressed. After the button is press, i can't get into the AP anymore.