Hello,
Who can assist me ?
I have a qnap 559 pro and i would like to improve the data throughput by using both lans to trunk them to an AGL on my 3com Baseline switch 2948-SFP Plus.
I have an AGL to port 27 and 28 ( free at the moment ) and i have setup the 559 pro to use trunking on the lans with IEEE802.3
Now i cannot see the IP anymore and the 559 is not seen by qfinder.
on the 559 i can set the ip to an adress in the range but this is what is visible:
1: on the switch i can see the connected speed of both lans ( 1000M full)
2: on the switch i can see both the macs of the 559
but i cannot reach the 559.
What can be the cause of this ?
it cant be a firewall issue because its internally on the network and it was visible when i used 1 cable.
Any advise would be welcome
Thanks in advance,
Eddy Gruben
Mark B.V.
Who can assist me ?
I have a qnap 559 pro and i would like to improve the data throughput by using both lans to trunk them to an AGL on my 3com Baseline switch 2948-SFP Plus.
I have an AGL to port 27 and 28 ( free at the moment ) and i have setup the 559 pro to use trunking on the lans with IEEE802.3
Now i cannot see the IP anymore and the 559 is not seen by qfinder.
on the 559 i can set the ip to an adress in the range but this is what is visible:
1: on the switch i can see the connected speed of both lans ( 1000M full)
2: on the switch i can see both the macs of the 559
but i cannot reach the 559.
What can be the cause of this ?
it cant be a firewall issue because its internally on the network and it was visible when i used 1 cable.
Any advise would be welcome
Thanks in advance,
Eddy Gruben
Mark B.V.
