[RESOLVED] NTP on AC68U Access Point won't sync

[skeal]

Just as the title says I rebooted after I updated the firmware to 384.16 and now the time won't sync no matter what I try. I do not have ssh access setup to it. It's just a basic AP. Any ideas guys? My main router is set to intercept time requests.

 

[skeal]

One more thing I noticed after the flash to the new firmware that my WPS was set to on and some of the wifi 2.4 settings were defaulted like channel and channel width. This AP has run on the previous firmware for a month without issue. Maybe factory reset.

 

[skeal]

May  4 23:08:38 rc_service: service 746:notify_rc restart_ntpd
May  4 23:08:38 ntpd: Stopped ntpd
May  4 23:08:38 ntpd: Started ntpd

Ok I factory reset and even with default settings no time sync still. I have ssh access now.

 

[skeal]

Resolved. I had to reboot the main router, and click apply on the system admin page.