Synology OpenVPN server - Where Asus routing rules

[chichow]

tl;dr Where do I put the routing rules via the GUI?

==
I am attempting to run 3 instances of OpenVPN server and have clients coming in over the WAN to access LAN resources and to force all traffic through the OpenVPN server including Internet access. I have set up the following.

• OpenVPN directly on the Asus router (192.168.1.1) using port 80 and 443
• OpenVPN on a Synology (192.168.1.x) in the LAN side of the Asus router using standard port
• The Synology OpenVPN assigns an address of 172.20.x.x)

For the Synology OpenVPN client config, when I use
push redirect-gateway def1, the VPN stops working. I believe I need to set a route back from the Synology to the Asus.

Where do I do this on the Asus? Thanks.

 

[ColinTaylor]

tl;dr Where do I put the routing rules via the GUI?

You can set static routes on the Asus at LAN > Route. But your questions seem to be about configuring the Synology rather than Merlin's firmware. Perhaps you need to ask your question in a VPN or Synology forum.