Turning on Ethernet Port Aggregation on the RAX200.

[Synomenon]

So on my R9000, I had port aggregation turned on for my QNAP. I had both of the QNAP's ethernet ports on the address reservation list of the router.

I configured the RAX200 the same way. Added the QNAP's ethernet ports in the address reservation list, connected port one to the RAX200 port 3 and port two to the RAX200 port 4.

Both have been rebooted. When I go to the RAX200's webUI -> ADVANCED -> Advanced Setup -> Ethernet Port Aggregation

I have "Enable (LACP - IEEE 802.3ad)" enabled.

It shows this though on that page, "Ethernet Port Aggregation Status: Inactive". Anyone know how to make it "Active"?

 

[Synomenon]

Never mind. Got it working. The webui of the RAX200 now shows it's active. I had to change it to "Static LAG".